Lines Matching refs:sent
61 Each received command will result in a response SLIP packet sent from the ESP chip to the host. Con…
321 …ystal and 115200bps with a 40MHz crystal. However the sync packets can be sent at any baud rate, a…
322 …ET_NAME} always initialises at 115200bps. However the sync packets can be sent at any baud rate, a…
325 …C0``), indicating that it is now running. This is the only unsolicited packet ever sent by the ESP.
346 …sent which contains basic parameters for the flash erase size, start address to write to, etc. The…
347 * One or more _DATA commands (FLASH_DATA, etc) is sent where the data payload contains the actual …
349 * An _END command (FLASH_END, etc) is sent to exit the bootloader and optionally reset the chip (o…
392 …M loader this command is not supported (SPI flash is enabled when the FLASH_BEGIN command is sent).
456 …6 byte MD5 digest of all the data which was read from flash. This is also sent as a raw SLIP packe…
467 …first group of arguments (before the command). This will dump all traffic sent and received via th…
483 …in the logs. The "Write X bytes" lines show exactly which bytes are being sent "over the wire", in…