Lines Matching refs:bytes

51 | 2-3    | Size        | Length of Data field, in bytes.                                           …
55 | 8..n   | Data        | Variable length data payload (0-65535 bytes, as indicated by Size paramete…
74 … | Size of data field. At least the length of the `Status Bytes`_ (2 or 4 bytes, see below).      …
81 Status bytes
84 The final bytes of the Data payload indicate command status:
88 …For stub loader and ESP8266 ROM loader the final two bytes indicate status (most commands return a…
92 …For stub loader the final two bytes indicate status (most commands return at least a two byte Data…
104 …_NAME} ROM (only, not the stub loader) the final four bytes are used, but only the first two bytes…
148 -  The status response is always 2 bytes regardless of chip type.
176 …NC           | `Sync Frame <#initial-synchronisation>`__             | 36 bytes: ``0x07 0x07 0x12 …
200 …    | `Sync Frame <#initial-synchronisation>`__                      | 36 bytes: ``0x07 0x07 0x12 …
206 …set-parameters>`__                  | Six 32-bit words: id, total size in bytes, block size, secto…
218 …                                  | Body contains 16 raw bytes of MD5 followed by 2 status bytes (…
238 …    | `Sync Frame <#initial-synchronisation>`__                      | 36 bytes: ``0x07 0x07 0x12 …
244 …set-parameters>`__                  | Six 32-bit words: id, total size in bytes, block size, secto…
257 …                                  | Body contains 16 raw bytes of MD5 followed by 2 status bytes (…
272 …n                | Two 32-bit words: flash offset to erase, erase size in bytes. Both must be mult…
298 The checksum is only applied to this final "data to write" section, not the first 16 bytes of data.
348    The last data block should be padded to the block size with 0xFF bytes.
376 …e of data to calculate. The MD5 value is returned in the response payload, before the status bytes.
380 …as 32 hex encoded ASCII bytes, whereas the stub loader returns the md5sum as 16 raw data bytes of …
426 …_NAME} ROM loader only, there is an additional 4 bytes in the data payload of this command. These …
454 …nd back a 4 byte raw SLIP acknowledgement packet with the total number of bytes which have been re…
474     TRACE +0.000 Write 14 bytes: c0000a0400000000001400f43fc0
475     TRACE +0.005 Read 1 bytes: c0
476     TRACE +0.000 Read 11 bytes: 010a0200620100000000c0
481 …inted in hexadecimal. If more than 16 bytes is printed at one time, a split display is used with h…
483 …e X bytes" lines show exactly which bytes are being sent "over the wire", including SLIP framing. …
484 Once a full SLIP packet is read, the same bytes - as a SLIP payload with any escaping removed - app…
486 Here is a second example showing part of the initial synchronization sequence (lots of 0x55 bytes w…
490     TRACE +0.000 Write 46 bytes:
494     TRACE +0.011 Read 1 bytes: c0
495     TRACE +0.000 Read 63 bytes: