Lines Matching refs:pins
21 …The following ESP8266 pins must be in a known state for either normal (flash boot) or serial bootl…
31 …If these pins are set differently to shown, nothing on the ESP8266 will work as expected. See `ESP…
54 …nal pull-up/pull-down resistor at {IDF_TARGET_STRAP_BOOT_GPIO} (and other pins). If you want to co…
56 …Information about {IDF_TARGET_NAME} strapping pins can also be found in the `{IDF_TARGET_NAME} Dat…
58 …ustom hardware, you will need to check the orientation of some "strapping pins" to get the correct…
102 …As well as the above mentioned pins, other ones influence the serial bootloader, please consult th…
106 …TARGET_STRAP_BOOT_GPIO} and {IDF_TARGET_STRAP_BOOT_2_GPIO}, the following pins influence the seria…
123 …rn connected to ``{IDF_TARGET_STRAP_BOOT_GPIO}`` and ``EN`` (``CHIP_PU``) pins of {IDF_TARGET_NAME…
131 …ial converter chip connected to ``{IDF_TARGET_STRAP_BOOT_GPIO}`` and ``EN`` pins of the ESP module.
151 … an automatic reset circuit for ``EN`` & ``{IDF_TARGET_STRAP_BOOT_GPIO}`` pins, but don't add a ca…
250 …``boot:0xNN (DESCRIPTION)`` is the hex value of the strapping pins, as represented in the `GPIO_ST…
275 …Consult the strapping pins shown above (in most cases, one of these modes is selected if {IDF_TARG…
287 Later output from the ROM bootloader depends on the strapping pins and
305 …e accidentally set to ``HSPI_FLASH_BOOT``, which uses different SPI flash pins. Check {IDF_TARGET_…
337 …:esp32: - Any other value indicates that SPI flash pins have been remapped via eFuse (the value i…
339 …stored in the bootloader header. This pin value is only used if SPI flash pins have been remapped …
341 …hd_drv:0x00,wp_drv:0x00`` Custom GPIO drive strength values for SPI flash pins. These are read fro…