Lines Matching full:v
10 … pin is incompatible with the DAT2 line pull-up if the flash voltage is 3.3 V. For more informatio…
39 - :ref:`strapping_conflicts_dat2` for models with 3.3 V flash chip
184 - Pull it up or drive it high either by using the host or with 3.3 V on VDD in 1-bit SD mode
196 …s will permanently configure the internal regulator's output voltage to 3.3 V, and GPIO12 will not…
200 …ing has a 3.3 V flash chip by checking the information on http://www.espressif.com/. If you burn t…
206 components/esptool_py/esptool/espefuse.py set_flash_voltage 3.3V
208 …he internal VDD_SDIO flash voltage regulator will be permanently set to 3.3 V. You will see the fo…
215 Enable internal flash voltage regulator (VDD_SDIO) to 3.3 V.
274 …ected, it will read low level at startup, which will lead to selecting the default 3.3 V operation.
276 …les, excluding ESP32-WROVER-B, use 1.8 V flash and have internal pull-ups on GPIO12. Other modules…
281 …- For boards using 1.8 V flash chips, GPIO12 needs to be pulled high at reset. This is fully compa…
282 …- On boards using the internal regulator and a 3.3 V flash chip, GPIO12 must be pulled low at rese…
320 - PU for 1.8 V flash; WPD for 3.3 V flash
321 - High for 1.8 V flash; Low for 3.3 V flash