Lines Matching refs:signals
35 * `Capture`_ external signals to provide additional control over the outputs
37 * Add a higher frequency `Carrier`_, if output signals are passed through an isolation transformer
44 …w many outputs and inputs are required, and what will be the sequence of signals to drive the moto…
58 …ization of two GPIOs as output signals within selected unit by calling :cpp:func:`mcpwm_gpio_init`…
68 …. turn it left or right, or vary the speed, we should apply some control signals to the unit's out…
92 …Synchronization signals are referred to using two different enumerations. First one :cpp:type:`mcp…
95 …signals by getting MCPWM counters to count up, down and up/down (automatically changing the count …
101 …input can be selected from other timers' synchronization outputs or GPIO signals via the GPIO matr…
144 …dware is able to detect the input signal's edge and measure time between signals. As result the co…
168 Each unit of the MCPWM is able to sense external signals with information about failure of the moto…
179 …lt signal inputs. This is done in analogous way as described for capture signals in section above.…
193 …signals through transformers. Any of A and B output signals may be at 100% duty and not changing w…