Lines Matching refs:connection

137 	bool "Use a separate workqueue for connection TX notify processing [EXPERIMENTAL]"
148 	int "Stack size of workqueue for connection TX notify processing"
152 	int "Cooperative priority of workqueue for connection TX notify processing"
156 	int "Init priority of workqueue for connection TX notify processing"
159 	  The connection TX notify processing workqueue is initialized during
340 	bool "Accept any values for connection parameters"
342 	  Some controllers support additional connection parameter ranges
344 	  allows the application to set any value to all connection parameters.
346 	  connection parameters (conn interval min and max, latency and timeout).
348 	  min and max connection intervals in order to verify whether the
349 	  desired parameters have been established in the connection.
352 	bool "Check if *conn is NULL when creating a connection"
357 	  errors where the application reuses the connection pointer of an
358 	  active connection object without dereferencing it. Without
359 	  dereferencing, the connection object stays alive which can lead to an
368 	  changes on the connection. The current PHY info is available in the
369 	  connection info.
376 	  Initiate PHY Update Procedure on connection establishment.
388 	  about Data Length changes on the connection. The current Data Length
389 	  info is available in the connection info.
396 	  Initiate Data Length Update Procedure on connection establishment.
406 	  stack. The remote information is retrieved once a connection has been
408 	  is available through the remote_info_available connection callback.
542 	  authenticated data in an unencrypted connection.
558 	  This option disables LE legacy pairing and forces LE secure connection
681 	  This option is the default value of the bonding flag for any ACL connection.
684 	  After a connection is established, the bonding flag of the connection
686 	  `the bonding flag per-connection` (BT_BONDABLE_PER_CONNECTION) is
698 	bool "Set/clear the bonding flag per-connection"
701 	  used to set/clear the bonding flag on a per-connection basis.
777 	int "Peripheral connection parameter update timeout in milliseconds"
782 	  starts the first connection parameters update procedure after a
783 	  connection has been established.
784 	  The connection parameters requested will be the parameters set by the
785 	  application, or the peripheral preferred connection parameters if
790 	  Update procedure within 5 seconds after establishing a connection."
793 	int "Peripheral connection parameter update retry attempts"
797 	  This value corresponds to number of times to retry connection
802 	int "Peripheral connection parameter update retry timeout in milliseconds"
807 	  to attempt requesting again the preferred connection parameters.
852 	  This will allow the application to initiate a connection
934 	bool "Support for receive of CTE in connection mode"
938 	  in connection mode.
941 	bool "Support for transmission of CTE in connection mode"
945 	  connection mode.
948 	bool "Support for CTE request procedure in connection mode"
951 	  Enable support for request of Constant Tone Extension in connection
955 	bool "Support for CTE request procedure in connection mode"
958 	  Enable support for request of Constant Tone Extension in connection
988 	bool "Use 16 bits signed integer IQ samples in connection IQ reports"
991 	  Direction Finging connection IQ reports provide a set of IQ samples collected during
994 	  extension to handle connection IQ report with samples that are in 16 bit signed integer
1063 	  the connection without the use of Debug keys.