Lines Matching full:connection
133 bool "Use a separate workqueue for connection TX notify processing [EXPERIMENTAL]"
144 int "Stack size of workqueue for connection TX notify processing"
148 int "Cooperative priority of workqueue for connection TX notify processing"
152 int "Init priority of workqueue for connection TX notify processing"
155 The connection TX notify processing workqueue is initialized during
336 bool "Accept any values for connection parameters"
338 Some controllers support additional connection parameter ranges
340 allows the application to set any value to all connection parameters.
342 connection parameters (conn interval min and max, latency and timeout).
344 min and max connection intervals in order to verify whether the
345 desired parameters have been established in the connection.
348 bool "Check if *conn is NULL when creating a connection"
353 errors where the application reuses the connection pointer of an
354 active connection object without dereferencing it. Without
355 dereferencing, the connection object stays alive which can lead to an
364 changes on the connection. The current PHY info is available in the
365 connection info.
372 Initiate PHY Update Procedure on connection establishment.
384 about Data Length changes on the connection. The current Data Length
385 info is available in the connection info.
392 Initiate Data Length Update Procedure on connection establishment.
402 stack. The remote information is retrieved once a connection has been
404 is available through the remote_info_available connection callback.
538 authenticated data in an unencrypted connection.
554 This option disables LE legacy pairing and forces LE secure connection
564 This option enables support for Secure Connection Only Mode. In this
677 This option is the default value of the bonding flag for any ACL connection.
680 After a connection is established, the bonding flag of the connection
682 `the bonding flag per-connection` (BT_BONDABLE_PER_CONNECTION) is
694 bool "Set/clear the bonding flag per-connection"
697 used to set/clear the bonding flag on a per-connection basis.
768 int "Timeout for pending LE Create Connection command in seconds"
773 int "Peripheral connection parameter update timeout in milliseconds"
778 starts the first connection parameters update procedure after a
779 connection has been established.
780 The connection parameters requested will be the parameters set by the
781 application, or the peripheral preferred connection parameters if
785 "The Peripheral device should not perform a Connection Parameter
786 Update procedure within 5 seconds after establishing a connection."
789 int "Peripheral connection parameter update retry attempts"
793 This value corresponds to number of times to retry connection
798 int "Peripheral connection parameter update retry timeout in milliseconds"
803 to attempt requesting again the preferred connection parameters.
848 This will allow the application to initiate a connection
930 bool "Support for receive of CTE in connection mode"
934 in connection mode.
937 bool "Support for transmission of CTE in connection mode"
941 connection mode.
944 bool "Support for CTE request procedure in connection mode"
947 Enable support for request of Constant Tone Extension in connection
951 bool "Support for CTE request procedure in connection mode"
954 Enable support for request of Constant Tone Extension in connection
984 bool "Use 16 bits signed integer IQ samples in connection IQ reports"
987 Direction Finging connection IQ reports provide a set of IQ samples collected during
990 extension to handle connection IQ report with samples that are in 16 bit signed integer
1071 the connection without the use of Debug keys.