Lines Matching full:hci
16 Controller. This value does not include the HCI ACL header.
27 The Controller will return this value in the HCI LE Read Buffer
48 The Controller will return this value in the HCI LE Read Buffer Size
63 the Host. This value does not include the HCI ACL header.
121 int "Maximum supported HCI Event buffer length"
128 Maximum supported HCI event buffer size. This value does not include
129 the HCI Event header.
131 sizes that include HCI events. It should be set according to the
132 expected HCI events that can be generated from the configuration.
133 If the subset of possible HCI events is unknown, this should be set to
137 int "Number of HCI Event buffers"
142 Number of buffers available for incoming HCI events from the
146 int "Maximum supported discardable HCI Event buffer length"
155 Maximum support discardable HCI event size of buffers in the separate
157 HCI Event header.
162 int "Number of discardable HCI Event buffers"
169 the HCI driver considers discardable. Examples of such events
176 int "Maximum support HCI Command buffer length"
185 Maximum data size for each HCI Command buffer. This value does not
186 include the HCI Command header.
188 sizes that include HCI commands. It should be set according to the
189 expected HCI commands that can be sent from the configuration.
190 If the subset of possible HCI commands is unknown, this should be set
196 int "Number of HCI command buffers" if !BT_HCI_RAW || !HAS_BT_CTLR
204 # the system work queue for HCI command Tx towards the Controller, one additional HCI
211 Number of buffers available for outgoing HCI commands from the Host.
213 HCI Controllers may not support Num_HCI_Command_Packets > 1, hence they default to 1 when
218 Normal HCI commands follow the HCI command flow control using Num_HCI_Command_Packets
219 return in HCI command complete and status.
221 The Host Number of Completed Packets command does not follow normal flow control of HCI
222 commands and the Controller side HCI drivers that allocates HCI command buffers with
228 HCI command flow control to be able to send Ncmd normal HCI commands and
239 ZEPHYR_BT_HCI := zephyr,bt-hci
243 default $(dt_chosen_bool_prop,$(ZEPHYR_BT_HCI),bt-hci-vs-ext)
246 for the Zephyr HCI Vendor-Specific Commands and Event.
249 bool "Zephyr HCI Vendor-Specific Commands"
253 Enable support for the Zephyr HCI Vendor-Specific Commands in the
258 bool "Allow vendor specific HCI event Zephyr Fatal Error"
261 Enable emitting HCI Vendor-Specific events for system and Controller
265 bool "Use heuristics to guess HCI vendor extensions support in advance"
270 supports the HCI vendor extensions in advance, in order to prevent
275 bool "Mesh HCI Command support"
278 Enable support for the Bluetooth Mesh HCI Commands.
320 bool "Print HCI error codes as strings [EXPERIMENTAL]"
323 This configuration enables printing of HCI error