Lines Matching +full:pico +full:- +full:gpios

1 .. zephyr:code-sample:: bme280
3    :relevant-api: sensor_interface
14    https://www.bosch-sensortec.com/products/environmental-sensors/humidity-sensors-bme280/
24 or SPI. Configuration is done via :ref:`devicetree <dt-guide>`. The devicetree
34    https://www.bosch-sensortec.com/media/boschsensortec/downloads/datasheets/bst-bme280-ds002.pdf
36 Boards with a built-in BME280
42 .. zephyr-app-commands::
43    :zephyr-app: samples/sensor/bme280
53 .. zephyr-app-commands::
54    :zephyr-app: samples/sensor/bme280
56    :gen-args: -DDTC_OVERLAY_FILE=arduino_spi.overlay
59 works on any board with a properly configured Arduino pin-compatible SPI
68 .. zephyr-app-commands::
69    :zephyr-app: samples/sensor/bme280
71    :gen-args: -DDTC_OVERLAY_FILE=arduino_i2c.overlay
74 works on any board with a properly configured Arduino pin-compatible I2C
77 BME280 via Raspberry Pi Pico
80 The default assignment of the built-in spi0 device on the :zephyr:board:`rpi_pico` is
84 .. zephyr-app-commands::
85    :zephyr-app: samples/sensor/bme280
94 .. zephyr-app-commands::
95    :zephyr-app: samples/sensor/bme280
98    :gen-args: -DDTC_OVERLAY_FILE=rpi_pico_spi_pio.overlay
100 Note that miso-gpios, mosi-gpios, and clk-gpios need to be assigned to the
101 selected PIO device in pinctrl, while cs-gpios should not;  chip select is
105 Board-specific overlays
109 a board-specific devicetree overlay adding one in the :file:`boards` directory.
119 .. zephyr-app-commands::
120    :zephyr-app: samples/sensor/bme280
134 .. code-block:: none
141    *** Booting Zephyr OS build zephyr-v2.4.0-2940-gbb732ada394f  ***
150 .. code-block:: none
158    *** Booting Zephyr OS build zephyr-v2.4.0-2940-gbb732ada394f  ***