Lines Matching +full:wakeup +full:- +full:source

1 .. zephyr:code-sample:: esp32-deep-sleep
13 This sample shows how to set a wake up source, trigger deep sleep and then
14 make use of that pre-configured wake up source to bring the system back again.
23 3. ``GPIO``: Only supported by some Espressif SoCs, in the case of ESP32-C3
24    GPIOS0~5 can be used as wake-up sources.
26 In this demo, Timer is the only wake-up source that cannot be disabled via a
28 as wake-up source, deep sleep for 20 seconds, wake up.
35 only ``Timer`` is used as wakeup source.
37 However, when ``EXT1`` is also enabled, GPIO2 and GPIO4 should be pulled-down
43 enabled as wake-up source.
46 ``prj.conf`` file. By default, this wake up source is enabled. Follow similar
52 .. zephyr-app-commands::
53    :zephyr-app: samples/boards/espressif/deep_sleep
61 -----------------
64 reset reason message depends on the wake up source used. The console output
67 .. code-block:: console
69    *** Booting Zephyr OS build zephyr-v3.1.0-3667-gb42e2b225ecf  ***
72    Enabling timer wakeup, 20s
73    Enabling EXT1 wakeup on pins GPIO2, GPIO4