Lines Matching full:application

33 	  the application. This removes the need by MCUboot to reset
59 	  for your application which is to be loaded by MCUboot. The MCUboot
136 	prompt "Application assumed MCUboot mode of operation"
139 	  Informs application build on assumed MCUboot mode of operation.
140 	  This is important for validataing application against DT configuration,
147 	  MCUboot will only boot slot0_partition placed application and does
148 	  not care about other slots. In this mode application is not able
157 	  in DT and application will boot from slot0_partition.
166 	  in DT and application will boot from slot0_partition.
182 	  to be present in DT, and application will boot from slot0_partition.
184 	  MCUboot swaps application from the secondary slot to the primary
212 	  to swap back to older version of the application.
221 	  select one with higher application image version, which usually
226 	  to swap back to older version of application.
235 	  In this mode MCUboot will boot the application with the higher version
237 	  next time for test or permanently. In case when application is marked
240 	  application.
241 	  This mode does not allow freely switching between application
242 	  versions, as, once higher version application is approved, it is
245 	  to downgrade running application, but note that MCUboot may do that
246 	  if application with higher version will not get confirmed.
252 	  MCUboot will only boot slot0_partition for the main application but has
254 	  a dedicated firmware updater application used to update the slot0_partition
255 	  application.
263 	  an application with lower version than the currently running application.
276 	bool "Application is firmware updater image"
293 	  required by the chain-loaded application and the MCUboot.
314 	  It is up to the application project to add source file which