Lines Matching +full:data +full:- +full:lanes

2 # SPDX-License-Identifier: Apache-2.0
8   data receivers, video data processors, etc. Data interfaces on these devices are
16   scheme using '#address-cells', '#size-cells' and 'reg' properties is used.
19   specify #address-cells, #size-cells properties independently for the 'port' and
25           #address-cells = <1>;
26           #size-cells = <0>;
37   Two 'endpoint' nodes must be linked with each other via their 'remote-endpoint'
39   references are currently not possible. A 'remote-endpoint-label' string is used
40   instead to be able to specify, at least, the label of the peer remote-endpoint.
44               compatible = "zephyr,video-interfaces";
45               remote-endpoint-label = "sink";
49               compatible = "zephyr,video-interfaces";
50               remote-endpoint-label = "source";
54   subnode for data exchange with other device. In most cases, properties at the
60   remote-endpoint-label:
64       Label of the 'remote-endpoint' subnode that interfaces with this endpoint.
65       This property is used as a 'work-around' to be able to declare the remote
66       endpoint and should be replaced by a "remote-endpoint" phandle property when
69   bus-type:
72       - 1 # MIPI CSI-2 C-PHY
73       - 2 # MIPI CSI1
74       - 3 # CCP2
75       - 4 # MIPI CSI-2 D-PHY
76       - 5 # Parallel
77       - 6 # BT.656
79       Data bus type.
81   data-shift:
84       On parallel data busses, if bus-width is used to specify the number of
85       data lines, data-shift can be used to specify which data lines are used,
86       e.g. "bus-width=<8>; data-shift=<2>;" means, that lines 9:2 are used.
88   hsync-active:
91       - 0 # low
92       - 1 # high
96   vsync-active:
99       - 0 # low
100       - 1 # high
104   pclk-sample:
107       - 0 # falling
108       - 1 # rising
109       - 2 # both
111       Sample data on falling, rising or both edges of the pixel clock signal.
113   link-frequencies:
116       Allowed data bus frequencies. For MIPI CSI-2, for instance, this is the
120   clock-lane:
125       a MIPI CSI-2 bus we could have "clock-lane = <0>;", which places the
127       only (e.g. MIPI CSI-2).
129   data-lanes:
132       An array of physical data lane indexes. Position of an entry determines
134       lane, e.g. for 2-lane MIPI CSI-2 bus we could have "data-lanes = <1 2>;",
138       lane. This property is valid for serial busses only (e.g. MIPI CSI-2).
141   bus-width:
144       Number of data lines actively used, only valid for parallel busses.