Lines Matching +full:drdy +full:- +full:pin

2 # SPDX-License-Identifier: Apache-2.0
5     When setting the odr, power-mode, and range properties in a .dts or .dtsi file you may include
8     #include <zephyr/dt-bindings/sensor/st_lis2dux12.h>
11       power-mode = <LIS2DUX12_OPER_MODE_LOW_POWER>;
16 include: sensor-device.yaml
19   int1-gpios:
20     type: phandle-array
22       INT1 pin
24       This pin defaults to active high when produced by the sensor.
27   int2-gpios:
28     type: phandle-array
30       INT2 pin
32       This pin defaults to active high when produced by the sensor.
36   drdy-pin:
40       - 1 # drdy is generated from INT1
41       - 2 # drdy is generated from INT2
43       Select DRDY pin number (1 or 2).
45       (INT1 or INT2) the drdy line is attached to. This property is not
47       configuration at power-up.
54       Range in g. Default is power-up configuration.
56       - 3  # LIS2DUX12_DT_FS_16G
57       - 2  # LIS2DUX12_DT_FS_8G
58       - 1  # LIS2DUX12_DT_FS_4G
59       - 0  # LIS2DUX12_DT_FS_2G
63   power-mode:
67       Specify the sensor power mode. Default is power-down mode
69       - 0 # LIS2DUX12_OPER_MODE_POWER_DOWN
70       - 1 # LIS2DUX12_OPER_MODE_LOW_POWER
71       - 2 # LIS2DUX12_OPER_MODE_HIGH_RESOLUTION
72       - 3 # LIS2DUX12_OPER_MODE_HIGH_FREQUENCY
81       Default is power-down mode
82       - 0  # LIS2DUX12_DT_ODR_OFF
83       - 1  # LIS2DUX12_DT_ODR_1Hz_ULP
84       - 2  # LIS2DUX12_DT_ODR_3Hz_ULP
85       - 3  # LIS2DUX12_DT_ODR_25Hz_ULP
86       - 4  # LIS2DUX12_DT_ODR_6Hz
87       - 5  # LIS2DUX12_DT_ODR_12Hz5
88       - 6  # LIS2DUX12_DT_ODR_25Hz
89       - 7  # LIS2DUX12_DT_ODR_50Hz
90       - 8  # LIS2DUX12_DT_ODR_100Hz
91       - 9  # LIS2DUX12_DT_ODR_200Hz
92       - 10 # LIS2DUX12_DT_ODR_400Hz
93       - 11 # LIS2DUX12_DT_ODR_800Hz