Lines Matching +full:10 +full:- +full:pin
2 # SPDX-License-Identifier: Apache-2.0
5 When setting the odr, power-mode, and range properties in a .dts or .dtsi file you may include
8 #include <zephyr/dt-bindings/sensor/st_lis2dux12.h>
11 power-mode = <LIS2DUX12_OPER_MODE_LOW_POWER>;
16 include: sensor-device.yaml
19 int1-gpios:
20 type: phandle-array
22 INT1 pin
24 This pin defaults to active high when produced by the sensor.
27 int2-gpios:
28 type: phandle-array
30 INT2 pin
32 This pin defaults to active high when produced by the sensor.
36 drdy-pin:
40 - 1 # drdy is generated from INT1
41 - 2 # drdy is generated from INT2
43 Select DRDY pin number (1 or 2).
47 configuration at power-up.
54 Range in g. Default is power-up configuration.
56 - 3 # LIS2DUX12_DT_FS_16G
57 - 2 # LIS2DUX12_DT_FS_8G
58 - 1 # LIS2DUX12_DT_FS_4G
59 - 0 # LIS2DUX12_DT_FS_2G
63 power-mode:
67 Specify the sensor power mode. Default is power-down mode
69 - 0 # LIS2DUX12_OPER_MODE_POWER_DOWN
70 - 1 # LIS2DUX12_OPER_MODE_LOW_POWER
71 - 2 # LIS2DUX12_OPER_MODE_HIGH_RESOLUTION
72 - 3 # LIS2DUX12_OPER_MODE_HIGH_FREQUENCY
81 Default is power-down mode
82 - 0 # LIS2DUX12_DT_ODR_OFF
83 - 1 # LIS2DUX12_DT_ODR_1Hz_ULP
84 - 2 # LIS2DUX12_DT_ODR_3Hz_ULP
85 - 3 # LIS2DUX12_DT_ODR_25Hz_ULP
86 - 4 # LIS2DUX12_DT_ODR_6Hz
87 - 5 # LIS2DUX12_DT_ODR_12Hz5
88 - 6 # LIS2DUX12_DT_ODR_25Hz
89 - 7 # LIS2DUX12_DT_ODR_50Hz
90 - 8 # LIS2DUX12_DT_ODR_100Hz
91 - 9 # LIS2DUX12_DT_ODR_200Hz
92 - 10 # LIS2DUX12_DT_ODR_400Hz
93 - 11 # LIS2DUX12_DT_ODR_800Hz
95 enum: [0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11]