Lines Matching +full:regulator +full:- +full:initial +full:- +full:mode

1 # Copyright 2019-2020, Peter Bigot Consulting, LLC
3 # SPDX-License-Identifier: Apache-2.0
9   linux/Documentation/devicetree/bindings/regulator/regulator.yaml.
14   regulator-name:
16     description: A string used as a descriptive name for regulator outputs
18   regulator-init-microvolt:
22   regulator-min-microvolt:
26   regulator-max-microvolt:
30   regulator-microvolt-offset:
34   regulator-init-microamp:
38   regulator-min-microamp:
42   regulator-max-microamp:
46   regulator-input-current-limit-microamp:
48     description: maximum input current regulator allows
50   regulator-always-on:
52     description: boolean, regulator should never be disabled
54   regulator-boot-on:
57       bootloader/firmware enabled regulator.
58       It's expected that this regulator was left on by the bootloader.
62       software cannot read the state of the regulator.
64   regulator-boot-off:
67       Regulator should be disabled on boot.
69   regulator-allow-bypass:
71     description: allow the regulator to go into bypass mode
73   regulator-allow-set-load:
75     description: allow the regulator performance level to be configured
77   regulator-ramp-delay:
80       ramp delay for regulator(in uV/us) For hardware which supports disabling
82       (regulator-ramp-delay = <0>) for disabling ramp delay.
84   regulator-enable-ramp-delay:
90       combination of internal ramping of the regulator itself, and board design
93   regulator-settling-time-us:
96       Settling time, in microseconds, for voltage change if regulator have the
97       constant time for any level voltage change. This is useful when regulator
100   regulator-settling-time-up-us:
103       Settling time, in microseconds, for voltage increase if the regulator
107   regulator-settling-time-down-us:
110       Settling time, in microseconds, for voltage decrease if the regulator
114   regulator-soft-start:
118   regulator-initial-mode:
121       Initial operating mode. The set of possible operating modes depends on the
123       explains which values the regulator supports.
125   regulator-allowed-modes:
129       regulator at run-time. Elements may be specified in any order. The set of
131       each device binding document explains which values the regulator supports.
133   regulator-system-load:
136       Load in uA present on regulator that is not captured by any consumer
139   regulator-pull-down:
141     description: Enable pull down resistor when the regulator is disabled.
143   regulator-over-current-protection:
147   regulator-oc-protection-microamp:
155   regulator-oc-error-microamp:
163   regulator-oc-warn-microamp:
172   regulator-ov-protection-microvolt:
178       omitted. Limit is given as microvolt offset from voltage set to regulator.
180   regulator-ov-error-microvolt:
187       microvolt offset from voltage set to regulator.
189   regulator-ov-warn-microvolt:
197       voltage set to regulator.
199   regulator-uv-protection-microvolt:
206       regulator.
208   regulator-uv-error-microvolt:
215       microvolt offset from voltage set to regulator.
217   regulator-uv-warn-microvolt:
225       voltage set to regulator.
227   regulator-temp-protection-kelvin:
235   regulator-temp-error-kelvin:
243   regulator-temp-warn-kelvin:
252   regulator-active-discharge:
255       - 0
256       - 1
263   regulator-max-step-microvolt:
269   startup-delay-us:
273   off-on-delay-us: