Lines Matching +full:clock +full:- +full:mode

2 # SPDX-License-Identifier: Apache-2.0
6 compatible: "st,stm32wb0-pwr"
8 include: "st,stm32-pwr.yaml"
11   smps-mode:
15       SMPS mode selection
18         - SMPS converter disabled
19         - LDOs supply voltage: VDD
22       'SMPS supply configuration', so this mode should NEVER be
23       selected on these boards. Only use this mode if your board
29         - SMPS converter enabled - clock disabled
30         - LDOs supply voltage: VDD (though SMPS)
31           - Current supplied to LDOs can be limited
35         - SMPS converter enabled - clock enabled
36         - LDOs supply voltage: regulated SMPS output
37           - Target output voltage can be programmed
39       - "OFF"
40       - "PRECHARGE"
41       - "RUN"
43   smps-bom:
54       This property is required if `smps-mode` is not "OFF".
56       - 1
57       - 2
58       - 3
60   smps-clock-prescaler:
64       SMPS clock prescaler factor
66       The SMPS clock, CLK_SMPS, comes from a 16 MHz source that
75       prescaler has been chosen. Since a slower clock results
78       This property is only used if `smps-mode` is not "OFF".
80       - 2
81       - 4
83   smps-lp-floating:
86       Floating SMPS output in low-power state
89       is left floating when the SoC is in low-power state.
92       PRECHARGE mode when the SoC is in low-power state.
95   smps-current-limit:
108       This property is only used if `smps-mode` is "PRECHARGE".
110       - "2_5"
111       - "5"
112       - "10"
113       - "20"
115   smps-output-voltage:
124       This property is only used if `smps-mode` is "RUN".
126       - "1V20"
127       - "1V25"
128       - "1V30"
129       - "1V35"
130       - "1V40"
131       - "1V45"
132       - "1V50"
133       - "1V55"
134       - "1V60"
135       - "1V65"
136       - "1V70"
137       - "1V75"
138       - "1V80"
139       - "1V85"
140       - "1V90"
141       - "1V95"