Lines Matching +full:device +full:- +full:pinmux

2 # SPDX-License-Identifier: Apache-2.0
12   peripheral with the same configuration properties. The 'pinmux' property in
16   For example, to configure the pinmux for UART0, modify the 'pinctrl' from your
20     #include <nxp/s32/S32K344-257BGA-pinctrl.h>
25           pinmux = <PTA3_LPUART0_TX_O>;
26           output-enable;
29           pinmux = <PTA28_LPUART0_RX>;
30           input-enable;
36   of a device. The 'default' state is the active state. Other states for the same
37   device can be specified in separate child nodes of 'pinctrl'.
39   In addition to 'pinmux' property, each group can contain other properties such as
40   'bias-pull-up' or 'slew-rate' that will be applied to all the pins defined in
41   'pinmux' array. To enable the input buffer use 'input-enable' and to enable the
42   output buffer use 'output-enable'.
44   To link the pin configurations with UART0 device, use pinctrl-N property in the
45   device node, where 'N' is the zero-based state index (0 is the default state).
49       pinctrl-0 = <&uart0_default>;
50       pinctrl-names = "default";
56     - input and output buffers disabled
57     - internal pull not enabled
58     - slew rate "fastest"
59     - invert disabled
60     - drive strength disabled.
64     - Safe Mode Control (disabled)
65     - Pad Keeping (disabled)
66     - Input Filter (disabled).
68 compatible: "nxp,s32k3-pinctrl"
72 child-binding:
74   child-binding:
78       - name: pincfg-node.yaml
79         property-allowlist:
80           - bias-disable
81           - bias-pull-down
82           - bias-pull-up
83           - input-enable
84           - output-enable
87       pinmux:
93           information in a 32-bit value.
95       slew-rate:
98           - "fastest"
99           - "slowest"
111       nxp,drive-strength: