Lines Matching +full:in +full:- +full:max

2 # SPDX-License-Identifier: Apache-2.0
7     use this node to route USART0 RX to pin PA10 and enable the pull-up resistor
10     The node has the 'pinctrl' node label set in your SoC's devicetree,
17     All device pin configurations should be placed in child nodes of the
18     'pinctrl' node, as shown in this example:
20       /* You can put this in places like a board-pinctrl.dtsi file in
21        * your board directory, or a devicetree overlay in your application.
24       /* include pre-defined combinations for the SoC variant used by the board */
25       #include <dt-bindings/pinctrl/gd32f450i(g-i-k)xx-pinctrl.h>
39             /* both PA10 and PA12 have pull-up enabled */
40             bias-pull-up;
47             /* configure PA9, PA10, PA11 and PA12 in analog mode */
53     particular state of a device; in this case, the default (that is, active)
55     for the sleep state (used in device low power mode). Note that analog mode
56     is used for low power states because it disconnects the pin pull-up/down
59     As shown, pin configurations are organized in groups within each child node.
60     Each group can specify a list of pin function selections in the 'pinmux'
64     pins, such as the 'bias-pull-up' property in group 2. Here is a list of
67     - drive-push-pull: Push-pull drive mode (default, not required).
68     - drive-open-drain: Open-drain drive mode.
69     - bias-disable: Disable pull-up/down (default, not required).
70     - bias-pull-up: Enable pull-up resistor.
71     - bias-pull-down: Enable pull-down resistor.
72     - slew-rate: Set the maximum speed (and so the slew-rate) of the output
77     To link pin configurations with a device, use a pinctrl-N property for some
78     number N, like this example you could place in your board's DTS file:
80        #include "board-pinctrl.dtsi"
83              pinctrl-0 = <&usart0_default>;
84              pinctrl-1 = <&usart0_sleep>;
85              pinctrl-names = "default", "sleep";
88 compatible: "gd,gd32-pinctrl-af"
90 include: gd,gd32-pinctrl-common.yaml
92 child-binding:
95   child-binding:
99       slew-rate:
101         default: "max-speed-2mhz"
103           - "max-speed-2mhz"
104           - "max-speed-25mhz"
105           - "max-speed-50mhz"
106           - "max-speed-200mhz"
109           slew rate of the output signal. Defaults to "max-speed-2mhz", the SoC