Lines Matching full:antenna
46 to use to drive antenna switching.
53 antenna switches depends on the use case. Nevertheless, at least two
64 antenna switch patterns to GPIOs.
66 Antenna switching patterns
69 An antenna switching pattern is a binary number where each bit is
70 applied to a particular antenna GPIO pin. For example, the pattern
71 0x3 means that antenna GPIOs at indexes 0 and 1 will be set, while
79 Antenna switch patterns are stored in DFE internal memory by
81 antenna switch patterns during Constant Tone Extension (CTE)
91 DFE uses SWITCHPATTERN[0] to select the antenna in this state.
92 (The 'dfe-pdu-antenna' property value described below is stored
96 of CTE. For this state, DFE selects the antenna by applying
101 antenna is the same as in the guard state.
103 * Switch-sample: in this state, actual antenna switching happens.
137 dfe-antenna-num:
145 dfe-pdu-antenna:
148 Antenna switch pattern to be used for transmission of PDU before start
153 This pattern is stored in SWITCHPATTERN[0] before actual antenna