Lines Matching +full:link +full:- +full:speed
3 # SPDX-License-Identifier: Apache-2.0
10 include: ethernet-controller.yaml
19 clock-frequency:
26 is determined by the current link speed reported by the PHY, to
27 which it will be adjusted at run-time. Therefore, the value of this
29 respective GEM's TX clock - by default, this is the IO PLL.
31 mdc-divider:
42 init-mdio-phy:
45 Activates the management of a PHY associated with the controller in-
46 stance. If this parameter is activated at the board level, the de-
47 fault values of the associated parameters mdio-phy-address, phy-poll-
48 interval, link-speed and advertise-lower-link-speeds should be checked
51 mdio-phy-address:
56 instance. Set the address to 0 for auto-detection (first responding
60 phy-poll-interval:
67 link-speed:
71 Nominal link speed. If no PHY is managed by an instance of this driver,
72 the respective controller will be configured to match the link speed
74 the link speed specified here will be requested. If the optional pro-
75 perty advertise-lower-link-speeds is set, advertisement of the link
76 speed specified here plus any valid link speed below this value will
79 - 1
80 - 2
81 - 3
83 advertise-lower-link-speeds:
87 the MDIO bus to include link speeds lower than the nominal value
88 set in the link-speed property in the advertisement when requesting
89 link speed auto-negotiation with a peer system.
91 handle-rx-in-isr:
102 handle-tx-in-workq:
106 context of the system work queue. By default, TX done handling is per-
108 of memory accesses. This option CAN NOT be used if any component ex-
112 amba-ahb-dbus-width:
117 - 0
118 - 1
119 - 2
121 amba-ahb-burst-length:
126 - 1
127 - 4
128 - 8
129 - 16
131 hw-rx-buffer-size:
138 - 0
139 - 1
140 - 2
141 - 3
143 hw-rx-buffer-offset:
148 0-3 bytes.
150 hw-tx-buffer-size-full:
157 rx-buffer-descriptors:
164 rx-buffer-size:
171 tx-buffer-descriptors:
178 tx-buffer-size:
185 ignore-ipg-rxer:
188 Optional feature flag - Ignore IPG rx_er. When set, rx_er has no
190 the RGMII wrapper in half-duplex mode.
192 disable-reject-nsp:
195 Optional feature flag - Receive bad preamble. When set, frames with
196 non-standard preamble will not be rejected.
198 ipg-stretch:
201 Optional feature flag - Enable IPG stretch. When set, the transmit
205 sgmii-mode:
208 Optional feature flag - Enable SGMII mode. Changes the behaviour of
209 the auto-negotiation advertisement and link partner ability registers
210 to meet the requirements of SGMII and reduces the duration of the link
213 disable-reject-fcs-crc-errors:
216 Optional feature flag - Disable rejection of FCS/CRC errors.
222 rx-halfdup-while-tx:
225 Optional feature flag - Enable frames to be received in half-duplex
228 rx-checksum-offload:
231 Optional feature flag - Enable RX IP/TCP/UDP checksum offload to
235 tx-checksum-offload:
238 Optional feature flag - Enable TX IP/TCP/UDP checksum offload to
242 disable-pause-copy:
245 Optional feature flag - Do not copy received pause frames to memory.
249 match is found or whether a type ID match is identified. If a desti-
254 discard-rx-fcs:
257 Optional feature flag - Remove FCS of received frames.
262 discard-rx-length-errors:
265 Optional feature flag - Discard frames with length field errors.
267 length field (as indicated by bytes 13 and 14 in a non-VLAN tagged
271 pause-frame:
274 Optional feature flag - Enable pause. When set, transmission will
281 Optional feature flag - Enable TBI. When set, the TBI interface is en-
284 ext-address-match:
287 Optional feature flag - Enable external address match. When set, the
290 long-frame-rx-support:
293 Optional feature flag - Enable reception of 1536 byte frames.
296 unicast-hash:
299 Optional feature flag - Enable unicast hash. When set, unicast frames
303 multicast-hash:
306 Optional feature flag - Enable multicast hash. When set, multicast
307 frames will be accepted when the 6 bit hash function of the desti-
310 reject-broadcast:
313 Optional feature flag - Reject broadcast frames. When set, frames
314 addressed to the all-ones broadcast address will be rejected.
316 promiscuous-mode:
319 Optional feature flag - Enable promiscuous mode. When set, all valid
322 discard-non-vlan:
324 description: Optional feature flag - Discard non-VLAN frames. When set,
327 full-duplex:
330 Optional feature flag - Enables full duplex reception and transmission.
332 discard-rx-frame-ahb-unavail:
335 Optional feature flag - Discard received packets when no AHB resource
338 ahb-packet-endian-swap:
341 Optional feature flag - Enable AHB packet data endianness swap to big
344 ahb-md-endian-swap:
347 Optional feature flag - Enable AHB management descriptor data endian-