Lines Matching full:save
482 int "RPU power save idle timeout in milliseconds"
626 So, to save resources, this option drops such networks from the scan results.
648 # Relies on power-save mode, so, LPM is needed and AP mode is not supported
675 int "RPU recovery power save active timeout in milliseconds"
678 Power save active timeout in milliseconds, after which the RPU recovery
680 RPU attempts to enter power save mode in case of inactivity.
719 bool "RPU recovery power save state debug logs"
721 Enable RPU recovery power save state debug logs to help debug the RPU recovery mechanism.
731 prompt "Power save data retrieval mechanism"
739 When the AP notifies about the availability of buffered data, the STA stays in power save
747 power save, and then AP can deliver all buffered frames without any additional
748 overhead or latency, but STA enters power save after a delay costing more power
779 prompt "Power save exit strategy"
782 Select the power save exit strategy to retrieve buffered data from AP.
785 bool "Exit power save every time to retrieve buffered data from AP"
787 Exit power save every time to retrieve buffered data from AP. Entering back to
788 power save mode might take some time and power.
791 bool "Exit power save based on an intelligent algorithm"
793 Exit power save based on an intelligent algorithm to retrieve buffered data from the AP.