Lines Matching refs:LOG_ERR

50 		LOG_ERR("Interrupt GPIO device not ready");  in tmd2620_configure_interrupt()
56 LOG_ERR("Failed to configure interrupt pin"); in tmd2620_configure_interrupt()
64 LOG_ERR("Failed to set GPIO callback"); in tmd2620_configure_interrupt()
87 LOG_ERR("Unsupported sensor channel"); in tmd2620_sample_fetch()
96 LOG_ERR("Failed enabling interrupt."); in tmd2620_sample_fetch()
107 LOG_ERR("Failed enabling device."); in tmd2620_sample_fetch()
117 LOG_ERR("Failed reading status register."); in tmd2620_sample_fetch()
127 LOG_ERR("Failed reading proximity data."); in tmd2620_sample_fetch()
138 LOG_ERR("Failed powering down device."); in tmd2620_sample_fetch()
146 LOG_ERR("Failed clearing interrupt flag."); in tmd2620_sample_fetch()
182 LOG_ERR("Failed reading chip id"); in tmd2620_sensor_setup()
187 LOG_ERR("Chip id is invalid! Device @%02x is no TMD2620!", config->i2c.addr); in tmd2620_sensor_setup()
193 LOG_ERR("ENABLE Register was not cleared"); in tmd2620_sensor_setup()
200 LOG_ERR("Failed setting wait time"); in tmd2620_sensor_setup()
207 LOG_ERR("Failed setting PILT"); in tmd2620_sensor_setup()
214 LOG_ERR("Failed setting PIHT"); in tmd2620_sensor_setup()
222 LOG_ERR("Failed setting PERS"); in tmd2620_sensor_setup()
235 LOG_ERR("Failed setting CFG0"); in tmd2620_sensor_setup()
253 LOG_ERR("Invalid proximity pulse length"); in tmd2620_sensor_setup()
260 LOG_ERR("Failed setting PPULSE"); in tmd2620_sensor_setup()
278 LOG_ERR("Invalid proximity gain"); in tmd2620_sensor_setup()
285 LOG_ERR("Failed setting PCGF1"); in tmd2620_sensor_setup()
292 LOG_ERR("Failed setting CFG3"); in tmd2620_sensor_setup()
299 LOG_ERR("Failed setting INTENAB"); in tmd2620_sensor_setup()
307 LOG_ERR("Failed enabling wait mode"); in tmd2620_sensor_setup()
325 LOG_ERR("I2C bus not ready!"); in tmd2620_init()
333 LOG_ERR("Failed to configure device"); in tmd2620_init()
341 LOG_ERR("Failed configuring interrupt!"); in tmd2620_init()
349 LOG_ERR("Failed enabling device."); in tmd2620_init()
369 LOG_ERR("Failed enabling sensor."); in tmd2620_pm_action()
378 LOG_ERR("Failed suspending sensor."); in tmd2620_pm_action()