Lines Matching +full:open +full:- +full:wire +full:- +full:on
4 # SPDX-License-Identifier: Apache-2.0
17 depends on DT_HAS_ZEPHYR_BT_HCI_UART_ENABLED
27 depends on DT_HAS_ZEPHYR_BT_HCI_3WIRE_UART_ENABLED
29 Bluetooth three-wire (H:5) UART driver. Implementation of HCI
30 Three-Wire UART Transport Layer.
35 depends on DT_HAS_ZEPHYR_BT_HCI_IPC_ENABLED
55 depends on BT_SPI
61 depends on DT_HAS_ZEPHYR_BT_HCI_SPI_ENABLED
70 depends on DT_HAS_ST_HCI_SPI_V1_ENABLED || DT_HAS_ST_HCI_SPI_V2_ENABLED
77 bool "ACI message with BlueNRG-based devices"
78 depends on BT_SPI_BLUENRG
82 Stack. Current driver supports: ST BLUENRG-MS.
87 depends on DT_HAS_ST_STM32WB_RF_ENABLED
97 depends on DT_HAS_ST_HCI_STM32WBA_ENABLED
98 depends on ZEPHYR_HAL_STM32_MODULE_BLOBS
107 depends on DT_HAS_ST_HCI_STM32WB0_ENABLED
108 depends on ZEPHYR_HAL_STM32_MODULE_BLOBS
121 depends on DT_HAS_SILABS_BT_HCI_EFR32_ENABLED
122 depends on ZEPHYR_HAL_SILABS_MODULE_BLOBS || BUILD_ONLY_NO_BLOBS
123 depends on !PM || SOC_GECKO_PM_BACKEND_PMGR
142 depends on (BOARD_NATIVE_POSIX || BOARD_NATIVE_SIM)
144 depends on DT_HAS_ZEPHYR_BT_HCI_USERCHAN_ENABLED
155 depends on DT_HAS_ESPRESSIF_ESP32_BT_HCI_ENABLED
156 depends on ZEPHYR_HAL_ESPRESSIF_MODULE_BLOBS || BUILD_ONLY_NO_BLOBS
163 depends on DT_HAS_INFINEON_CAT1_BLESS_HCI_ENABLED
164 depends on ZEPHYR_HAL_INFINEON_MODULE_BLOBS
173 depends on DT_HAS_RENESAS_BT_HCI_DA1453X_ENABLED
177 running on DA1453x MCU.
182 depends on DT_HAS_RENESAS_BT_HCI_DA1469X_ENABLED
185 on DA1469x MCU.
190 depends on DT_HAS_NXP_HCI_BLE_ENABLED
198 depends on DT_HAS_INFINEON_CYW208XX_HCI_ENABLED
206 depends on DT_HAS_AMBIQ_BT_HCI_SPI_ENABLED
224 depends on BT_STM32_IPM
236 depends on DT_HAS_INFINEON_CYW43XXX_BT_HCI_ENABLED || DT_HAS_INFINEON_CYW208XX_HCI_ENABLED
238 Infineon's AIROC™ Wi-Fi & combos portfolio integrates
239 IEEE 802.11a/b/g/n/ac/ax Wi-Fi and Bluetooth® 5.2 in a single-chip
240 solution to enable small-form-factor IoT designs.
246 bool "Host auto-initiated Data Length Update quirk"
247 depends on BT_AUTO_DATA_LEN_UPDATE
250 Enable the quirk wherein BT Host stack will auto-initiate Data Length
252 auto-initiate the procedure if the default data length parameters are
256 open source controller.
265 public identity through vendor-specific commands. They can then implement the
274 Enable the HCI vendor-specific Setup function.
277 of the vendor-specific commands sequence to initialize the BT Controller
281 configuration files. This option are enabled by the vendor-specific
302 depends on BT_SILABS_EFR32
311 depends on BT_H4
315 depends on DT_HAS_NXP_BT_HCI_UART_ENABLED
318 More inforamtion about NXP Bluetooth profuct could be found on
319 …https://www.nxp.com/products/wireless-connectivity/wi-fi-plus-bluetooth-plus-802-15-4:WIFI-BLUETOO…