Lines Matching refs:new
39 :c:macro:`DEVICE_DT_DEFINE`. It also includes a new backend API pointer to
66 removed in favor of new :dtcompatible:`zephyr,flash-disk` devicetree binding.
160 This should now be configured using the new ``lse_bypass`` property of
303 use the new API by following the :ref:`migration guide <mcumgr_cb_migration>`
414 * Added a new ``BT_CONN_INTERVAL_TO_US`` utility macro.
422 * Added a new :c:func:`bt_le_per_adv_sync_lookup_index` function.
434 * Added a new :kconfig:option:`BT_ID_ALLOW_UNAUTH_OVERWRITE` that allows
464 * Added a new ``LL_ASSERT_MSG`` macro for verbose assertions.
668 * Removed :c:macro:`BOOT_TRAILER_IMG_STATUS_OFFS` in favor a two new functions;
745 * STM32: Flash driver was revisited to simplify reuse of driver for new series, taking
786 * Added a new target device API :c:func:`i3c_target_tx_write` to
792 * Added a new driver to support Cadence I3C controller.
812 * Added new API :c:func:`pcie_scan` to scan for devices.
818 use this new API.
821 a new device has been discovered.
875 * Refactored NXP PCA9420 driver to align with the new API.
878 * Added a new test that allows to verify regulator output voltage using the
880 * Added a new test that checks API behavior provided we have a well-behaved
902 enable a new sensor info iterable section and shell command. See
904 * Refactored all sensor devicetree bindings to inherit new base sensor device
998 * Added new experimental USB device controller (UDC) API and implementation
1000 * Added new experimental USB host controller (UDC) API and implementation
1078 * Added new LwM2M APIs for historical data storage for LwM2M resource.
1097 * Updated various networking test suites to use the new ztest API.
1172 * Added new USB device stack (device_next), class implementation for CDC ACM and
1275 - :dtcompatible:`gd,gd322-dma` has new helper macros to easily setup the ``dma-cells`` property.
1402 - :dtcompatible:`sbs,sbs-gauge-new-api`
1485 Additionally, all DMA controller devices have new
1493 - new property: ``vendor-id``
1494 - new property: ``device-id``
1499 - new property: ``interrupt-map-mask``
1500 - new property: ``interrupt-map``
1501 - new property: ``bus-range``
1510 - new property: ``debounce-interval-ms``
1516 - new property: ``write-fifo-depth``
1522 - new property: ``pinctrl-0``
1523 - new property: ``pinctrl-1``
1524 - new property: ``pinctrl-2``
1525 - new property: ``pinctrl-3``
1526 - new property: ``pinctrl-4``
1527 - new property: ``pinctrl-names``
1538 - new property: ``loopback``
1548 - new property: ``scl-timeout-us``
1552 - new property: ``dma-enabled``
1553 - new property: ``dma-clk``
1554 - new property: ``dma-host``
1562 - new property: ``gd,mem2mem``
1577 - new property: ``fifo-start-offset``
1578 - new property: ``fifo-tx-size``
1579 - new property: ``fifo-rx-size``
1589 - new property: ``vendor-id``
1590 - new property: ``device-id``
1595 - new property: ``fifo``
1602 - new property: ``pp-od-mask``
1603 - new property: ``pullup-mask``
1604 - new property: ``gpio-group``
1616 - new property: ``mxicy,mx25r-power-mode``
1622 - new property: ``wakerx-gpios``
1626 - new property: ``clk32kmon-period-min``
1627 - new property: ``clk32kmon-period-max``
1628 - new property: ``clk32kmon-duty-cycle-var-max``
1629 - new property: ``clk32kmon-valid-min``
1630 - new property: ``xtal-enable-delay-ms``
1631 - new property: ``pll-lock-timeout-ms``
1632 - new property: ``clkmon-bypass``
1633 - new property: ``internal-osc-disable``
1634 - new property: ``pinctrl-0``
1635 - new property: ``pinctrl-names``
1636 - new property: ``pinctrl-1``
1637 - new property: ``pinctrl-2``
1638 - new property: ``pinctrl-3``
1639 - new property: ``pinctrl-4``
1644 - new property: ``port-sel``
1645 - new property: ``chip-select``
1654 - new property: ``supply-voltage-mv``
1658 - new property: ``mxicy,mx25r-power-mode``
1664 - new property: ``pinctrl-0``
1665 - new property: ``pinctrl-1``
1666 - new property: ``pinctrl-2``
1667 - new property: ``pinctrl-3``
1668 - new property: ``pinctrl-4``
1669 - new property: ``pinctrl-names``
1673 - new property: ``status``
1674 - new property: ``compatible``
1675 - new property: ``reg``
1676 - new property: ``reg-names``
1677 - new property: ``interrupts``
1678 - new property: ``interrupts-extended``
1679 - new property: ``interrupt-names``
1680 - new property: ``interrupt-parent``
1681 - new property: ``label``
1682 - new property: ``clocks``
1683 - new property: ``clock-names``
1684 - new property: ``#address-cells``
1685 - new property: ``#size-cells``
1686 - new property: ``dmas``
1687 - new property: ``dma-names``
1688 - new property: ``io-channel-names``
1689 - new property: ``mboxes``
1690 - new property: ``mbox-names``
1691 - new property: ``wakeup-source``
1692 - new property: ``power-domain``
1698 - new property: ``nxp,rs485-mode``
1699 - new property: ``nxp,rs485-de-active-low``
1703 - new property: ``reset-gpios``
1708 - new property: ``nxp,prescaler``
1709 - new property: ``nxp,reload``
1714 - new property: ``mmc-hs200-1_8v``
1715 - new property: ``mmc-hs400-1_8v``
1719 - new property: ``mmc-hs200-1_8v``
1720 - new property: ``mmc-hs400-1_8v``
1726 - new property: ``vendor-id``
1727 - new property: ``device-id``
1739 - new property: ``pinctrl-0``
1740 - new property: ``pinctrl-1``
1741 - new property: ``pinctrl-2``
1742 - new property: ``pinctrl-3``
1743 - new property: ``pinctrl-4``
1744 - new property: ``pinctrl-names``
1755 - new property: ``pinctrl-0``
1756 - new property: ``pinctrl-1``
1757 - new property: ``pinctrl-2``
1758 - new property: ``pinctrl-3``
1759 - new property: ``pinctrl-4``
1760 - new property: ``pinctrl-names``
1770 - new property: ``rgb-is-inverted``
1776 - new property: ``vendor-id``
1777 - new property: ``device-id``
1798 - new property: ``reset-cmd``
1799 - new property: ``reset-cmd-wait``
1803 - new property: ``resets``
1804 - new property: ``tx-rx-swap``
1805 - new property: ``reset-names``
1809 - new property: ``resets``
1810 - new property: ``tx-rx-swap``
1811 - new property: ``reset-names``
1815 - new property: ``resets``
1816 - new property: ``tx-rx-swap``
1817 - new property: ``reset-names``
1821 - new property: ``num-lines``
1822 - new property: ``line-ranges``
1823 - new property: ``interrupt-controller``
1824 - new property: ``#interrupt-cells``
1834 - new property: ``otgfspre``
1838 - new property: ``otgfspre``
1842 - new property: ``otgfspre``
1850 - new property: ``lse-bypass``
1854 - new property: ``anym-no-latch``
1855 - new property: ``anym-mode``
1859 - new property: ``drdy-pulsed``
1863 - new property: ``anym-no-latch``
1864 - new property: ``anym-mode``
1868 - new property: ``anym-no-latch``
1869 - new property: ``anym-mode``
1873 - new property: ``anym-no-latch``
1874 - new property: ``anym-mode``
1878 - new property: ``drdy-pulsed``
1882 - new property: ``odr``
1883 - new property: ``ff-duration``
1884 - new property: ``ff-threshold``
1888 - new property: ``drdy-pulsed``
1892 - new property: ``anym-no-latch``
1893 - new property: ``anym-mode``
1897 - new property: ``anym-no-latch``
1898 - new property: ``anym-mode``
1902 - new property: ``odr``
1903 - new property: ``ff-duration``
1904 - new property: ``ff-threshold``
1908 - new property: ``anym-no-latch``
1909 - new property: ``anym-mode``
1913 - new property: ``drdy-pulsed``
1917 - new property: ``resets``
1918 - new property: ``reset-names``
1922 - new property: ``dead-battery``
1923 - new property: ``pinctrl-0``
1924 - new property: ``pinctrl-names``
1925 - new property: ``pinctrl-1``
1926 - new property: ``pinctrl-2``
1927 - new property: ``pinctrl-3``
1928 - new property: ``pinctrl-4``
1932 - new property: ``resets``
1933 - new property: ``reset-names``
1937 - new property: ``st,static-prescaler``
1938 - new property: ``reset-names``
1948 - new property: ``current-lsb-microamps``
1949 - new property: ``rshunt-milliohms``
1950 - new property: ``alert-gpios``
1957 - new property: ``current-lsb-microamps``
1958 - new property: ``rshunt-milliohms``
1959 - new property: ``alert-gpios``
1968 - new property: ``bias-disable``
1969 - new property: ``bias-high-impedance``
1970 - new property: ``bias-bus-hold``
1971 - new property: ``bias-pull-up``
1972 - new property: ``bias-pull-down``
1973 - new property: ``bias-pull-pin-default``
1974 - new property: ``drive-push-pull``
1975 - new property: ``drive-open-drain``
1976 - new property: ``drive-open-source``
1977 - new property: ``drive-strength``
1978 - new property: ``drive-strength-microamp``
1979 - new property: ``input-enable``
1980 - new property: ``input-disable``
1981 - new property: ``input-schmitt-enable``
1982 - new property: ``input-schmitt-disable``
1983 - new property: ``input-debounce``
1984 - new property: ``power-source``
1985 - new property: ``low-power-enable``
1986 - new property: ``low-power-disable``
1987 - new property: ``output-disable``
1988 - new property: ``output-enable``
1989 - new property: ``output-low``
1990 - new property: ``output-high``
1991 - new property: ``sleep-hardware-state``
1992 - new property: ``slew-rate``
1993 - new property: ``skew-delay``
1999 - new property: ``tx-fifo-size``
2000 - new property: ``rx-fifo-size``
2020 * Added new pinctrl definitions for STM32F1xx PWM input. In PWM capture mode
2022 The new names takes the form tim1_ch1_pwm_in_pa8 for example.
2025 from newly created inputs. The new names takes the form tim1_ch1_pwm_out_pa8
2072 * Added no-throwing implementation of new operator to the C++ minimal
2074 * Added support for new operator with alignment request (C++17) to the C++
2081 * Introduced new Cache API
2095 * Added new API call `fs_mkfs`.
2096 * Added new sample `samples/subsys/fs/format`.
2143 * A new MCUmgr transport function pointer has been added which needs
2192 to make transition to new Kconfig options easier.
2193 Below table provides information on old names and new equivalents:
2379 * MCUmgr img_mgmt has a new field which is sent in the final packet (if
2407 * Added a new Storage Abstraction to isolate both flash operations and
3603 * :github:`47477` - qemu_leon3: tests/kernel/fpu_sharing/generic/ failed when migrating to new ztes…
3613 * :github:`47092` - driver: nrf: uarte: new dirver breaks our implementation for uart.
3614 * :github:`47040` - tests: drivers: gpio_basic_api and gpio_api_1pin: convert to new ztest API
3618 * :github:`46897` - tests: posix: fs: improve tests to take better advantage of new ztest features
3620 * :github:`46824` - Prevent new uses of old ztest API
3638 * :github:`45625` - LE Audio: Update CSIP API with new naming scheme
3639 * :github:`45621` - LE Audio: Update VCP API with new naming scheme
3699 * :github:`41380` - stm32h7: Ethernet: Migrate driver to the new eth HAL api