Lines Matching full:added
14 * Added support for armclang / armlinker toolchain
15 * Added support for MWDT C / C++ toolchain
26 * Added Support for Service Type Enumeration (STE) with mDNS / DNS Service Discovery
27 * Added Zephyr Thread Awareness for OpenOCD to West
29 * Added both Ethernet MDIO and Ethernet generic PHY drivers
34 * We added support for SOCKS5 proxy
36 * We added support for Point-to-Point Protocol (PPP)
37 * We added support for UpdateHub, an end-to-end solution for over-the-air device updates
38 * We added support for ARM Cortex-R Architecture
41 * Added support for numerous new boards and shields
42 * Added numerous new drivers and sensors
43 * Added BLE support on Vega platform
45 * We added initial support for 64-bit ARMv8-A architecture
47 * LoRa support was added along with the SX1276 LoRa modem driver
56 * Added Bluetooth host support for periodic advertisement and isochronous channels.
57 * Added a new TCP stack which improves network protocol testability
61 * Added Thread Local Storage (TLS) support
62 * Added support for per thread runtime statistics
63 * Added support for building with LLVM on X86
64 * Added new synchronization mechanisms using Condition Variables
67 * Added support for 64-bit ARCv3
69 * Added initial support for Arm v8.1-m and Cortex-M55
71 * Tracing subsystem overhaul / added support for Percepio Tracealyzer
73 * Automatic SPDX SBOM generation has been added to West
74 * Added an example standalone Zephyr application
195 * Added :c:struct:`multiple` to the :c:struct:`bt_gatt_read_params` - this
201 * Added IPv4 address support to the multicast group join/leave monitor. The
227 * Added support for FPU in QEMU for Cortex-M, allowing to build and execute
229 * Added MPU support for Cortex-R
237 * Added support to RISC-V CPU devicetree compatible bindings
238 * Added support to link with ITCM & DTCM sections
252 * Added the Microphone Input Control Service and client.
255 * Added support for a new sent callback to be notified when an SDU has been
260 * Added configurability for conditional CTE RX support
261 * Added support for CTE periodic advertising chain transmissions
265 * Added support for setting more than 251 bytes of advertising data
266 * Added new callbacks on ATT MTU update
267 * Added a new call to retrieve the handle of an advertising set
269 * Added configuration support for GATT security re-establishment
270 * Added support for writing a long device name
271 * OTS: Added object name write capability
275 * Added return value for opcode callback
276 * Added support for OOB Public Key in the provisionee role
277 * Added a new API to manually store pending RPL entries
278 * Added support for application access to mesh messages
283 * Added support for advertising PDU chaining, implementing advertising trains
285 * Added support for adding or removing the ACAD field in Common Extended
290 * Added support for Extended Active Scanning
291 * Added support for advertising on the S2 and S8 coding schemes
292 * Added support for the Periodic Advertising channel map update indication
302 * Added support for these SoC series:
304 * Added STM32U5 basic SoC support
311 * Added Atmel SAM0 pinctrl support
312 * Added Atmel SAM4L USBC device controller
313 * Added Atmel GMAC support for MDIO driver
314 * Added Atmel GMAC support to use generic PHY driver
315 * Added Atmel SAM counter (TC) Driver
316 * Added Atmel SAM DAC (DACC) driver
320 * Added low power support to STM32L0, STM32G0 and STM32WL series
322 * STM32: Added Kconfig option to enable STM32Cube asserts (CONFIG_USE_STM32_ASSERT)
323 * NXP FRDM-K82F: Added arduino_i2c and arduino_spi aliases
324 * NXP i.MX RT series: Added support for flash controller with XIP
325 * NXP i.MX RT series: Added TRNG support
326 * NXP i.MX RT1170: Added LPSPI driver support
327 * NXP i.MX RT1170: Added ADC driver support
329 * NXP i.MX RT1170: Added MCUX FlexCan support
330 * NXP i.MX RT1064: Added watchdog driver support
331 * NXP i.MX RT1064: Added DMA driver support
332 * NXP i.MX RT600: Added arduino serial port
334 * NXP i.MX RT600: Added counter support
335 * NXP i.MX RT600: Added PWM support
336 * NXP i.MX RT600: Added disk driver support
337 * NXP i.MX RT600: Added USB driver support
338 * NXP i.MX RT600: Added LPADC driver support
339 * NXP i.MX RT600: Added CTimer Counter support
340 * NXP KE1xF: Added SoC Power Management support
341 * NXP LPC55s69: Added USB driver support
342 * NXP LPC55s69: Added ctimer driver support
343 * NXP LPC55s69: Added I2S driver support
355 * Added SPI support on Arduino standard SPI when possible
357 * Added support for these ARM boards:
367 * Added support for these ARM64 boards:
378 * arduino_due: Added support for TC driver
379 * atsame54_xpro: Added support for PHY driver
380 * sam4l_ek: Added support for TC driver
381 * sam4e_xpro: Added support for PHY driver
382 * sam4e_xpro: Added support for TC driver
383 * sam4s_xplained: Added support for TC driver
384 * sam_e70_xplained: Added support for DACC driver
385 * sam_e70_xplained: Added support for PHY driver
386 * sam_e70_xplained: Added support for TC driver
387 * sam_v71_xult: Added support for DACC driver
388 * sam_v71_xult: Added support for PHY driver
389 * sam_v71_xult: Added support for TC driver
391 * cy8ckit_062_ble: Added arduino's nexus map
394 * Added support for these following shields:
404 * Added STM32WL ADC driver
405 * STM32: Added support for oversampling
406 * Added driver for Microchip MEC172x
410 * Added DMIC driver for nRF PDM peripherals
417 * Renesas R-Car driver added
429 * Added STM32WL RTC counter driver
437 * Added Atmel SAM DAC (DACC) driver
438 * Added support for Microchip MCP4725
439 * Added support for STM32F3 series
443 * Added SDMMC support on STM32L4+
445 * Added USDHC support for i.MX RT685
449 * Added support for ST7735R
453 * Added Atmel SAM XDMAC reload support
454 * Added support on STM32F3, STM32G0, STM32H7 and STM32L5
460 * Added support for EEPROM emulated in flash.
464 * Added support for STM32F2, STM32G0, STM32WB and STM32WL
468 * Added support for Microchip eSPI SAF
472 * Added Atmel SAM/SAM0 GMAC devicetree support
473 * Added Atmel SAM/SAM0 MDIO driver
474 * Added MDIO driver
475 * Added generic PHY driver
480 * Added STM32F2, STM32L5 and STM32WL Flash driver support
482 * Added quad SPI support for STM32F4
495 * Added Atmel SAM I2S driver support to XDMAC reload
496 * Added driver for nRF I2S peripherals
518 * Added STM32F4 support
523 * Added gsm_ppp devicetree support
529 * Added ability to retrieve extended PCI/PCIe capabilities.
533 * Added Atmel SAM0 pinctrl support
541 * Added driver for ITE IT8XXX2 series
542 * Added driver for NXP LPC devices
543 * Added driver for Telink B91
557 * Added Sensirion SGP40 multipixel gas sensor driver.
558 * Added Sensirion SHTCX humidity sensor driver.
559 * Added Sensirion SHT4X temperature and humidity sensor driver.
560 * Added SiLabs SI7270 hall effect magnetic position and temperature sensor
562 * Added ST I3G4250D gyroscope driver.
563 * Added TI INA219 and INA23X current/power monitor drivers.
564 * Added TI LM75 and LM77 temperature sensor drivers.
565 * Added TI HDC20XX humidity and temperature sensor driver.
569 * Added kconfig to disable runtime re-configuration of UART
571 * Added ESP32-C3 polling only UART driver.
572 * Added ESP32-S2 polling only UART driver.
573 * Added Microchip XEC UART driver.
583 * Added Atmel SAM4L USBC device controller driver
584 * Added support for NXP LPC USB controller
589 * Added STM32L5 watchdog support
602 * Added an optional destination address filtering in the 802.15.4 L2.
606 * Added ``user_data`` field to the :c:struct:`coap_packet` structure.
629 * Added Service Type Enumeration support (``_services._dns_sd._udp.local``)
644 * Added support for notification timeout reporting to the application.
649 * Added mutex protection for the state variable of the ``lwm2m_rd_client``
662 * Added RX/TX timeout on a socket in ``big_http_download`` sample.
664 Added IEEE 802.15.4 security-related flags to the :c:struct:`net_pkt`
666 * Added bridging support to the Ethernet L2.
669 * Added an option to suppress ICMP destination unreachable errors.
675 * Added an option to register a custom transport type.
682 Added several new Kconfig options to align with new OpenThread
684 * Added OpenThread API mutex protection during initialization.
688 * Added possibility to disable CSL sampling, when used.
695 * Added microsecond accuracy in :c:func:`zsock_select` function.
731 * Added new header file where all defines and structures from Chapter 9
738 * Added support to store alternate interface setting.
739 * Added ``zephyr_udc0`` nodelabel to all boards with USB support to allow
1002 * Added a new sample to showcase the PSA Protecter Storage service.
1684 * :github:`36117` - toolchain: The added abstraction for llvm, breaks builds with off-tree llvm bas…
1923 * :github:`21869` - IPv6 neighbors get added too eagerly