Lines Matching full:added
84 * Added a new API for recovering an I2C bus from situations where the I2C
184 * A new general purpose memory allocator, sys_heap/k_heap, has been added
225 * Added CMSIS-DSP library integration
226 * Added semihosting console support
233 * Added processor exception handling and reporting framework for Cortex-R
234 * Added nested interrupt support on AArch32 Cortex-R and AArch64 Cortex-A
241 * Added support for building on ARM hosts
245 * Added support for hard floating point for RISC-V
246 * Added march and mabi options to Kconfig
252 * Added ability for SoC to add MMU regions
259 * Added support for these SoC series:
268 * Added support for these ARM boards:
292 * Added support for these following shields:
304 * Added support for STM32G4, STM32L1 and STM32H7 series
306 * Added Microchip MCP320x driver
314 * Added an RX thread on stm32wb hci wrapper
317 - Added Resolvable Private Address support
319 - Added 2 Mbps PHY support
335 * Added semihosting console
339 * Added support on stm32h7 and stm32l0
341 * Added Maxim DS3231 driver
342 * Added NXP Kinetis LPTMR driver
346 * Added driver for nRF ECB
347 * Added CAP_NO_IV_PREFIX capability to stm32 driver
351 * Added stm32l0 series support
352 * Added DAC shell
353 * Added NXP Kinetis DAC and DAC32 drivers
361 * Added power management support to st7789v driver
385 * Added SAM E54 max queue count referencing
386 * Added SAM0 family support to gmac driver
387 * Added sam4e support to queue in gmac
388 * Added network power management support to mcux
389 * Added VLAN support to enc28j60
390 * Added VLAN support to stm32
391 * Added Ethernet cable link status support to gmac
392 * Added support for i.MXRT1060 family to mcux
393 * Added support for getting manual MAC address from devicetree
394 * Added support for enabling random MAC address from devicetree
402 * Added logs on stm32
405 * Added driver for AT456 compatible SPI flash chips
410 * Added mcp23s17 driver
411 * Added STM32L5 support to stm32 driver
412 * Added interrupt support to sx1509b driver
415 * Added MCP23S17 driver
425 * Added support to stm32h7
426 * Added write/read and bus recovery commands to shell
427 * Added bus recovery function to gpio bitbang driver
429 * Added mcux flexcomm driver
433 * Added I2S master DMA support and clock output to stm32 driver
438 * Added Decawave DW1000 driver
439 * Added "no auto start" option and local MAC address support to rf2xx
440 * Added support for Frame Pending Bit (FPB) handling in nrf5
441 * Added CSMA CA transmit capability to nrf5
442 * Added PAN coordinator mode support to nrf5
443 * Added support for promiscuous mode to nrf5
444 * Added support for energy scan function to nrf5
451 * Added support for STM32L5 series
452 * Added GIC V3 driver
458 * Added CAVS DSP Intra-DSP Communication (IDC) driver
462 * Added interrupt support to the ft5336 touch controller driver
463 * Added SDL mouse driver
475 * Added a LoRa shell
481 * Added support for GSM 07.10 muxing protocol to generic GSM modem
482 * Added support for modem commands that do not have a line ending
483 * Added automatic detection of ublox-sara-r4 modem type
484 * Added automatic setting of APN for ublox-sara-r4
485 * Added sendmsg() support to ublox-sara-r4
493 * Added Microchip XEC driver
505 * Added support to stm32h7
507 * Added mcux tpm driver
512 * Added support for Analog Devices ADXL345 3-axis I2C accelerometer
513 * Added Infineon DPS310 driver
515 * Added Honeywell MPR driver
516 * Added BQ27421 driver
517 * Added weighted average filter to NXP Kinetis temperature driver
519 * Added forced sampling mode to BME280 driver
520 * Added IIS2MDC magnetometer driver
521 * Added IIS2DLPC accelerometer driver
522 * Added ISM330DHCX IMU driver
523 * Added MEC tachometer driver
528 * Added uart_mux driver that is used in GSM 07.10 muxing protocol
529 * Added support for parity setting from dts on stm32
530 * Added support for stm32l5
532 * Added XMC driver
533 * Added interrupt and runtime configuration support to Xilinx driver
536 * Added SAMV71 support to sam driver
540 * Added support for DMA client on stm32
542 * Added power management support to cc13xx_cc26xx driver
550 * Added CAVS DSP wall clock timer driver
555 * Added experimental USB Audio implementation.
556 * Added support to stm32wb
563 * Added dedicated video init priority
569 * Added support on stm32g0
574 * Added scan completion indication to eswifi
575 * Added support to ESP8266 and ESP32
583 * Added minimal support for TFTP client (RFC 1350)
584 * Added support for network device driver power management
585 * Added support for socketpair() BSD socket API
586 * Added support for QEMU user networking (SLIRP)
587 * Added support to disable automatic network attachment in OpenThread
588 * Added support for Frame Pending Bit handling in OpenThread
589 * Added support for RX frame handling in OpenThread
590 * Added support for TX started notification in OpenThread
591 * Added support for HW CSMA CA in OpenThread
592 * Added support for promiscuous mode in OpenThread
593 * Added support for reading OPAQUE resources with OMA TLV in LWM2M
594 * Added config to enable PAN coordinator mode in IEEE 802.15.4
595 * Added config to enable promiscuous mode in IEEE 802.15.4
596 * Added support for subscribe in Azure cloud sample
597 * Added support for queue mode in lwm2m_client sample
598 * Added support to allow change of the QEMU Ethernet interface name
599 * Added support for PPP IPCP to negotiate used DNS servers
600 * Added support for setting hostname in DHCPv4 request
622 * Support for LE Advertising Extensions has been added.
626 * Legacy OOB pairing support has been added.
634 * A new HCI USB H4 driver has been added, which can interact with BlueZ's
672 * A new :ref:`devicetree_api` was added. This API is not generated, but is
679 :ref:`dt-from-c` API usage guide was also added.
710 * New API overview page added.
720 * Added samples for USB Audio Class.
721 * Added sample for using POSIX read()/write() with network sockets.
792 * :github:`25698` - IPv6 prefix could be added multiple times to prefix timer list