Lines Matching full:added
14 * Added support for numerous new boards and shields.
15 * Added numerous new drivers and sensors.
16 * Added new TCP stack implementation (experimental).
17 * Added BLE support on Vega platform (experimental).
49 * Added support for memory protection features (user mode and
51 * Added QEMU support for ARMv6-M architecture
57 * Added CMSIS support for Cortex-R architectures.
59 * Added missing Cortex-R CPU device tree bindings.
65 * Added support for CONFIG_DYNAMIC_INTERRUPTS (native_posix
81 * Added support for these SoC series:
90 * Added support for these ARM boards:
112 * Added support for these following shields:
124 * Added CAN support for Olimexino STM32 board
131 * Added support for STM32G4X in STM32 driver
132 * Added Microchip XEC ADC driver
136 * Added RPMsg transport HCI driver
140 * Added API to read the bus-state and error counters
141 * Added API for bus-off recovery
147 * Added support for nRF52833 in nRF driver
148 * Added support for STM32G4X in STM32 driver
156 * Added support for STM32L1 and STM32G4X in STM32 driver
158 * Added Microchip XEC driver
167 * Added generic STM32 driver
172 * Added EEPROM device driver API
173 * Added Atmel AT24 (and compatible) I2C EEPROM driver
174 * Added Atmel AT25 (and compatible) SPI EEPROM driver
175 * Added native_posix EEPROM emulation driver
179 * Added RV32M1 driver
180 * Added support for STM32G4X in STM32 driver
184 * Added MAC address configuration and carrier state detection to STM32 driver
185 * Added ENC424J600 driver
190 * Added deep-power-down mode support in SPI NOR driver
192 * Added support for STM32G4X in STM32 driver
197 * Added support for STM32G4X in STM32 driver
202 * Added LiteX DNA driver
207 * Added support for STM32G4X in STM32 driver
210 * Added proper error handling in XEC driver
218 * Added CC13xx / CC26xx driver
222 * Added support for SAME54 to SAM0 EIC driver
223 * Added support for STM32G4X in STM32 driver
228 * Added nRFx driver
232 * Added Microchip XEC driver
240 * Added simple power management to modem receiver
244 * Added support for STM32G4X in STM32 driver
249 * Added Microchip XEC driver
253 * Added PWM shell
254 * Added Microchip XEC driver
262 * Added OPT3001 light sensor driver
263 * Added SI7060 temperature sensor driver
264 * Added TMP116 driver
266 * Added single/double tap trigger support in LIS2DW12 driver
270 * Added support for SAME54 to SAM0 driver
271 * Added support for STM32G4X in STM32 driver
272 * Added support for 2 stop bits in nRF UARTE and UART drivers
274 * Added ESP32 driver with FIFO/interrupt support
278 * Added support for nRF52833 in nRFx driver
279 * Added support for STM32G4X in STM32 driver
280 * Added RV32M1 driver
281 * Added Microchip XEC driver
282 * Added LiteX driver
292 * Added STM32 LPTIM driver
297 * Added support for nRF52833 in nRFx driver
298 * Added support for STM32G4X in STM32 driver
303 * Added MCUX CSI and Aptina MT9M114 drivers
304 * Added software video pattern generator driver
308 * Added support for SAME54 to SAM0 driver
311 * Added STM32 WWDG driver
312 * Added Microchip XEC driver
321 * Added new TCP stack implementation. The new TCP stack is still experimental
324 * Added support for running MQTT protocol on top of a Websocket connection.
325 * Added support for enabling DNS in LWM2M.
326 * Added support for resetting network statistics in net-shell.
327 * Added support for getting statistics about the time it took to receive or send
329 * Added support for sending a PPP Echo-Reply packet when a Echo-Request packet
331 * Added CC13xx / CC26xx device drivers for IEEE 802.15.4.
332 * Added TCP/UDP socket offload with TLS for eswifi network driver.
333 * Added support for sending multiple SNTP requests to increase reliability.
334 * Added support for choosing a default network protocol in socket() call.
335 * Added support for selecting either native IP stack, which is the default, or
338 * Added support for LWM2M client initiated de-register.
375 * GATT: Added a ``bt_gatt_is_subscribed()`` function to check if attribute has been subscribed
376 * GATT: Added an initializer for GATT CCC structures
377 * HCI: Added a function to get the connection handle of a connection
378 * Added ability to load CCC settings on demand to reduce memory usage
381 * Added key displacement feature for key storage
383 * Added support C++20 designated initializers
385 * Mesh: Added support for acting as a Provisioner
391 * Added experimental BLE support on Vega platform.
392 * Added a hook for flushing in LLL
395 * Added support for Zero Latency IRQs