Lines Matching +full:regulator +full:- +full:over +full:- +full:current +full:- +full:protection
39 to define default flash and ram partitioning based on TF-M.
60 specify it using the west ``--runner`` or ``-r`` option. (:github:`75284`)
61 * ADC: Domain clock needs to be explicitly defined if property st,adc-clock-source = <ASYNC> is use…
85 Trusted Firmware-M
88 * The security counter used for the hardware rollback protection now comes explicitly from
130 Chip variants with open-drain outputs (``mcp23x09``, ``mcp23x18``) now correctly reflect this in
134 * The ``power-domain`` property has been removed in favor of ``power-domains``.
136 ``power-domain-names`` is also available to optionally name each entry in
137 ``power-domains``. The number of cells in the ``power-domains`` property need
138 to be defined using ``#power-domain-cells``.
143 * For all STM32 ADC that selects an asynchronous clock through ``st,adc-clock-source`` property,
163 .. code-block:: devicetree
167 load-capacitors = "external";
172 load-capacitors = "internal";
173 load-capacitance-picofarad = <...>;
178 .. code-block:: devicetree
182 load-capacitors = "external";
189 load-capacitors = "internal";
190 load-capacitance-femtofarad = <...>;
197 TinyCrypt-based shim driver was marked as deprecated (:github:`79653`).
202 * The SDMMC subsystem driver now requires a ``disk-name`` property be supplied
205 registered simultaneously. If unsure, ``disk-name = "SD"`` may be used
208 * The MMC subsystem driver now requires a ``disk-name`` property be supplied
211 registered simultaneously. If unsure, ``disk-name = "SD2"`` may be used
221 * The u-blox M10 driver has been renamed to M8 as it only supports M8 based devices.
222 Existing devicetree compatibles should be updated to :dtcompatible:`u-blox,m8`, and Kconfig
233 the current behavior it can be set to ``NULL``. A ``void *user_data``
236 * The :dtcompatible:`analog-axis` ``invert`` property has been renamed to
237 ``invert-input`` (there's now an ``invert-output`` available as well).
244 If the :dtcompatible:`raspberry,pico-pwm`'s ``divider-int-0`` or variations
247 The driver will operate at the specified division ratio if a non-zero value is
248 specified for ``divider-int-0``.
250 Please specify ``divider-int-0`` explicitly to make the same behavior as before.
258 devicetree property ``detect-cd`` should be added to the USDHC node in use.
265 :dtcompatible:`jedec,jc-42.4-temp` compatible string instead to the ``microchip,mcp9808`` string.
266 * The :dtcompatible:`current-sense-amplifier` sense resistor is now specified in milli-ohms
267 …(``sense-resistor-milli-ohms``) instead of micro-ohms in order to increase the maximum representab…
269 * The :dtcompatible:`current-sense-amplifier` properties ``sense-gain-mult`` and ``sense-gain-div``
273 * The ``nxp,`` prefixed properties in :dtcompatible:`nxp,kinetis-acmp` have been deprecated in favor
274 of properties without the prefix. The sensor based driver for the :dtcompatible:`nxp,kinetis-acmp`
287 Regulator subsection
295 :kconfig:option:`CONFIG_SOC_DCDC_NRF53X_HV` selected by board-level Kconfig
300 .. code-block:: devicetree
304 regulator-initial-mode = <NRF5X_REG_MODE_DCDC>;
314 .. code-block:: devicetree
318 regulator-initial-mode = <NRF5X_REG_MODE_DCDC>;
323 regulator-initial-mode = <NRF5X_REG_MODE_DCDC>;
337 * The ``bt-hci-bus`` and ``bt-hci-quirks`` devicetree properties for HCI bindings have been changed
338 to use lower-case strings without the ``BT_HCI_QUIRK_`` and ``BT_HCI_BUS_`` prefixes.
357 compile-time maximum configuration of ASEs to be used.
380 related functionality without requiring build-time configuration. Existing need to be updated
391 do a search-and-replace for ``bt_audio_codec_qos`` to ``bt_bap_qos_cfg`` and
408 ---------------------------------------------
412 This deprecation is compiler-checked. If you get no warnings,
440 .. code-block:: diff
442 -bt_le_ext_adv_create(BT_LE_ADV_CONN, ...)
445 .. code-block:: diff
447 -bt_le_ext_adv_update_param(..., BT_LE_ADV_CONN)
472 For this case, the application has to take over the
529 :ref:`pm-device-runtime` on the device (Tunable with
554 of TinyCrypt in the CTR-DRBG random number generator was removed. From now on
580 They replace the previously-existing Kconfigs ``CONFIG_JWT_SIGN_RSA`` and