Lines Matching +full:github +full:- +full:token
37 :ref:`native_sim<native_sim>` (:github:`76898`).
39 to define default flash and ram partitioning based on TF-M.
60 specify it using the west ``--runner`` or ``-r`` option. (:github:`75284`)
61 * ADC: Domain clock needs to be explicitly defined if property st,adc-clock-source = <ASYNC> is use…
70 …have been removed because Mbed TLS doesn't support TLS 1.0 and 1.1 anymore since v3.0. (:github:`7…
71 * The following Kconfig symbols were renamed (:github:`76408`):
77 be enabled. (:github:`77657`)
85 Trusted Firmware-M
91 versions larger than ``0.0.1024`` (:github:`78128`).
100 Full release notes at https://github.com/NordicSemiconductor/zcbor/blob/0.9.0/RELEASE_NOTES.md
101 Migration guide at https://github.com/NordicSemiconductor/zcbor/blob/0.9.0/MIGRATION_GUIDE.md
121 ``litex,eth0`` to :dtcompatible:`litex,liteeth`. (:github:`75433`)
124 ``litex,uart0`` to :dtcompatible:`litex,uart`. (:github:`74522`)
130 Chip variants with open-drain outputs (``mcp23x09``, ``mcp23x18``) now correctly reflect this in
132 :c:func:`gpio_pin_set`. (:github:`65797`)
134 * The ``power-domain`` property has been removed in favor of ``power-domains``.
136 ``power-domain-names`` is also available to optionally name each entry in
137 ``power-domains``. The number of cells in the ``power-domains`` property need
138 to be defined using ``#power-domain-cells``.
143 * For all STM32 ADC that selects an asynchronous clock through ``st,adc-clock-source`` property,
163 .. code-block:: devicetree
167 load-capacitors = "external";
172 load-capacitors = "internal";
173 load-capacitance-picofarad = <...>;
178 .. code-block:: devicetree
182 load-capacitors = "external";
189 load-capacitors = "internal";
190 load-capacitance-femtofarad = <...>;
196 * Following the deprecation of the TinyCrypt library (:github:`79566`), the
197 TinyCrypt-based shim driver was marked as deprecated (:github:`79653`).
202 * The SDMMC subsystem driver now requires a ``disk-name`` property be supplied
205 registered simultaneously. If unsure, ``disk-name = "SD"`` may be used
208 * The MMC subsystem driver now requires a ``disk-name`` property be supplied
211 registered simultaneously. If unsure, ``disk-name = "SD2"`` may be used
221 * The u-blox M10 driver has been renamed to M8 as it only supports M8 based devices.
222 Existing devicetree compatibles should be updated to :dtcompatible:`u-blox,m8`, and Kconfig
226 been removed. (:github:`76392`)
236 * The :dtcompatible:`analog-axis` ``invert`` property has been renamed to
237 ``invert-input`` (there's now an ``invert-output`` available as well).
244 If the :dtcompatible:`raspberry,pico-pwm`'s ``divider-int-0`` or variations
247 The driver will operate at the specified division ratio if a non-zero value is
248 specified for ``divider-int-0``.
250 Please specify ``divider-int-0`` explicitly to make the same behavior as before.
258 devicetree property ``detect-cd`` should be added to the USDHC node in use.
265 :dtcompatible:`jedec,jc-42.4-temp` compatible string instead to the ``microchip,mcp9808`` string.
266 * The :dtcompatible:`current-sense-amplifier` sense resistor is now specified in milli-ohms
267 …(``sense-resistor-milli-ohms``) instead of micro-ohms in order to increase the maximum representab…
269 * The :dtcompatible:`current-sense-amplifier` properties ``sense-gain-mult`` and ``sense-gain-div``
273 * The ``nxp,`` prefixed properties in :dtcompatible:`nxp,kinetis-acmp` have been deprecated in favor
274 of properties without the prefix. The sensor based driver for the :dtcompatible:`nxp,kinetis-acmp`
295 :kconfig:option:`CONFIG_SOC_DCDC_NRF53X_HV` selected by board-level Kconfig
300 .. code-block:: devicetree
304 regulator-initial-mode = <NRF5X_REG_MODE_DCDC>;
314 .. code-block:: devicetree
318 regulator-initial-mode = <NRF5X_REG_MODE_DCDC>;
323 regulator-initial-mode = <NRF5X_REG_MODE_DCDC>;
337 * The ``bt-hci-bus`` and ``bt-hci-quirks`` devicetree properties for HCI bindings have been changed
338 to use lower-case strings without the ``BT_HCI_QUIRK_`` and ``BT_HCI_BUS_`` prefixes.
349 (:github:`76992`)
357 compile-time maximum configuration of ASEs to be used.
362 (:github:`76632`)
367 (:github:`78877`)
371 (:github:`78999`)
380 related functionality without requiring build-time configuration. Existing need to be updated
382 (:github:`78751`)
387 (:github:`76108`)
391 do a search-and-replace for ``bt_audio_codec_qos`` to ``bt_bap_qos_cfg`` and
392 ``BT_AUDIO_CODEC_QOS`` to ``BT_BAP_QOS_CFG``. (:github:`76633`)
399 :c:func:`bt_bap_broadcast_source_get_id` has been removed(:github:`80228`)
402 used instead. (:github:`80217`)
408 ---------------------------------------------
412 This deprecation is compiler-checked. If you get no warnings,
440 .. code-block:: diff
442 -bt_le_ext_adv_create(BT_LE_ADV_CONN, ...)
445 .. code-block:: diff
447 -bt_le_ext_adv_update_param(..., BT_LE_ADV_CONN)
486 parameter, to store the value of the more flag. (:github:`76052`)
489 :kconfig:option:`CONFIG_COAP_RANDOMIZE_ACK_TIMEOUT` is enabled. (:github:`79058`)
493 After this change the bridge shell is used by ``net bridge`` command. (:github:`77235`)
505 will take network interface pointer as a first parameter. (:github:`77987`)
509 implementation moved to :zephyr_file:`lib/net_buf/`. (:github:`78009`)
512 …``NET_SOCKET_SERVICE_SYNC_DEFINE_STATIC`` has been removed as it was always ignored. (:github:`794…
516 ``struct net_socket_service_event *pev`` parameter. (:github:`80041`)
529 :ref:`pm-device-runtime` on the device (Tunable with
536 ``true`` for the same behavior as before the change. (:github:`71037`)
541 The configuration part of hawkbit is now in ``<zephyr/mgmt/hawkbit/config.h>``. (:github:`71037`)
553 * Following the deprecation of the TinyCrypt library (:github:`79566`), usage
554 of TinyCrypt in the CTR-DRBG random number generator was removed. From now on
556 (:github:`79653`)
564 JWT (JSON Web Token)
568 (:github:`78243`). The conversion to the PSA Crypto API is part of the adoption
569 of a standard interface for crypto operations (:github:`43712`). Moreover,
570 following the deprecation of the TinyCrypt library (:github:`79566`), usage
571 of TinyCrypt was removed from the JWT subsystem (:github:`79653`).
580 They replace the previously-existing Kconfigs ``CONFIG_JWT_SIGN_RSA`` and
581 ``CONFIG_JWT_SIGN_ECDSA``. (:github:`79653`)