Lines Matching full:can
3 CAN Transceiver
13 A CAN transceiver is an external device that converts the logic level signals
14 from the CAN controller to the bus-levels. The bus lines are called
15 CAN High (CAN H) and CAN Low (CAN L).
16 The transmit wire from the controller to the transceiver is called CAN TX,
17 and the receive wire is called CAN RX.
19 differentially between CAN H and CAN L.
20 The bus can be either in the recessive (logical one) or dominant (logical zero)
21 state. The recessive state is when both lines, CAN H and CAN L, are roughly at
23 To write a dominant bit to the bus, open-drain transistors tie CAN H to Vdd
24 and CAN L to ground.
25 The first and last node use a 120-ohm resistor between CAN H and CAN L to
32 :alt: CAN Transceiver
34 CAN Transceiver API Reference