Lines Matching full:shown

62 The properties of a given CAN controller can be inspected using the ``can show`` subcommand as shown
111 subcommand as shown below. The bitrate is specified in bits per second.
119 the ``can dbitrate`` subcommand as shown below. The bitrate is specified in bits per second.
138 subcommand. An example for enabling loopback mode is shown below.
153 ``can start`` subcommand as shown below. This will enable reception and transmission of CAN frames.
161 stop`` subcommand as shown below:
172 added using the ``can filter add`` subcommand as shown below. The subcommand accepts a CAN ID in
185 Received CAN frames matching the added filter(s) are printed to the shell. A few examples are shown…
233 Configured CAN RX filters can be removed again using the ``can filter remove`` subcommand as shown
245 CAN frames can be queued for transmission using the ``can send`` subcommand as shown below. The
260 as shown below: