Lines Matching +full:raw +full:- +full:y +full:- +full:max

38 For example, building the :zephyr:code-sample:`hello_world` sample for the :zephyr:board:`frdm_k64f…
41 .. zephyr-app-commands::
42    :zephyr-app: samples/hello_world
44 …:gen-args: -DCONFIG_SHELL=y -DCONFIG_CAN=y -DCONFIG_CAN_SHELL=y -DCONFIG_STATS=y -DCONFIG_CAN_STAT…
48 interact with the shell. The CAN shell comes with built-in help (unless
49 :kconfig:option:`CONFIG_SHELL_HELP` is disabled). The built-in help messages can be printed by
50 passing ``-h`` or ``--help`` to the ``can`` command or any of its subcommands. All subcommands also
51 support tab-completion of their arguments.
55    also supports tab-completion. A list of all devices available can be obtained using the ``device
67 .. code-block:: console
71    max bitrate:     5000000 bps
72    max std filters: 15
73    max ext filters: 15
74    capabilities:    normal loopback listen-only fd
103    is the initial setting upon boot-up. The initial CAN controller mode is set to ``normal`` and the
104    initial timing is set according to the ``bitrate``, ``sample-point``, ``bitrate-data``, and
105    ``sample-point-data`` :ref:`devicetree` properties.
113 .. code-block:: console
121 .. code-block:: console
130 It is also possible to configure the raw bit timing using the ``can timing`` and ``can dtiming``
140 .. code-block:: console
146 loopback`` for setting CAN FD and loopback mode). Vendor-specific modes can be specified in
155 .. code-block:: console
163 .. code-block:: console
177 .. code-block:: console
180 …adding filter with standard (11-bit) CAN ID 0x010, CAN ID mask 0x7ff, data frames 1, RTR frames 0,…
187 .. code-block:: console
190    can0  --       010   [8]  01 02 03 04 05 06 07 08
191    can0  B-       010  [08]  01 02 03 04 05 06 07 08
193    can0  --  00000010   [0]
194    can0  --       010   [1]  20
195    can0  --       010   [8]  remote transmission request
207     in error-passive state.
208   * ``-``: Unset flag.
212   * ``010``: The standard (11-bit) CAN ID of the frame in hexadecimal format, here 10h.
213   * ``00000010``: The extended (29-bit) CAN ID of the frame in hexadecimal format, here 10h.
231    timestamp from the free-running timestamp counter in the CAN controller.
237 .. code-block:: console
250 .. code-block:: console
253    enqueuing CAN frame #2 with standard (11-bit) CAN ID 0x010, RTR 0, CAN FD 0, BRS 0, DLC 8
259 The ``can recover`` subcommand can be used for initiating manual recovery from a CAN bus-off event
262 .. code-block:: console