Lines Matching refs:firmware

30 the microcontroller the debug probe firmware runs on.
32 onboard debug probe microcontroller can support one or more types of firmware
34 OpenSDA microcontroller can be programmed with DAPLink firmware to communicate
35 with pyOCD or OpenOCD debug host tools, or with J-Link firmware to communicate
99 - :ref:`mcu-link-cmsis-onboard-debug-probe` (default firmware)
111 This is the default firmware installed on MCU-Link debug probes.  The CMSIS-DAP
128 required to program the CMSIS-DAP firmware:
148 This debug probe firmware provides a JLink compatible debug interface,
154 These probes do not have JLink firmware installed by default, and must be
156 required to program the JLink firmware:
181 - :ref:`lpclink2-daplink-onboard-debug-probe` (default firmware)
203 This debug probe firmware is compatible with the following debug host tools:
207 The probe may be updated to use CMSIS-DAP firmware with the following steps:
226 .. note:: On some boards, the J-Link probe firmware will no longer power the
228    of powering the board must be used when this firmware is programmed.
230 This debug probe firmware provides a JLink compatible debug interface,
236 The probe may be updated to use the J-Link firmware with the following steps:
238 .. note:: Verify the firmware supports your board by visiting `Firmware for LPCXpresso`_
257 The LPC-Link2 DAPLink firmware is the default firmware shipped on LPC-Link2
258 based boards, but is not the recommended firmware. Users should update to
259 the :ref:`lpclink2-cmsis-onboard-debug-probe` firmware following the
260 instructions provided above. For details on programming the DAPLink firmware,
271 - :ref:`opensda-daplink-onboard-debug-probe` (default firmware)
279 This debug probe firmware is compatible with the following debug host tools:
286 OpenSDA firmware. NXP provides `OpenSDA DAPLink Board-Specific Firmwares`_.
288 Install the debug host tools before you program the firmware.
290 As with all OpenSDA debug probes, the steps for programming the firmware are:
303 #. Copy the OpenSDA firmware binary to the USB mass storage device.
320 OpenSDA firmware. Segger provides `OpenSDA J-Link Generic Firmwares`_ and
326 Install the debug host tools before you program the firmware.
328 As with all OpenSDA debug probes, the steps for programming the firmware are:
341 #. Copy the OpenSDA firmware binary to the USB mass storage device.
361 Install the debug host tools before you program the firmware.
383 to work with J-Link. To do this, SEGGER offers a firmware upgrading the
384 ST-LINK/V2-1 on board on the Nucleo and Discovery boards. This firmware makes
390 firmware please visit: `Segger over ST-Link`_
459 Updating or restoring ST-Link firmware
462 ST-Link firmware can be updated using `STM32CubeProgrammer Tool`_.
466 Once installed, you can update attached board ST-Link firmware with the
489 the firmware.