Lines Matching full:tools

9 the Zephyr application on your host workstation using tools like GDB. They may
12 software supported by Zephyr, see :ref:`flash-debug-host-tools`.
33 that communicate with their respective debug host tools. For example, an
35 with pyOCD or OpenOCD debug host tools, or with J-Link firmware to communicate
36 with J-Link debug host tools.
40 || *Debug Probes & Host Tools*             |                                               Host Too…
102 This probe is programmed using the MCU-Link host tools, which are installed
103 with the :ref:`linkserver-debug-host-tools`. NXP recommends using NXP's
104 `MCUXpresso Installer`_ to install the Linkserver tools.
123 This debug probe is compatible with the following debug host tools:
125 - :ref:`linkserver-debug-host-tools`
127 Once the MCU-Link host tools are installed, the following steps are
131    be done by installing :ref:`linkserver-debug-host-tools`.
150 tools:
152 - :ref:`jlink-debug-host-tools`
155 updated. Once the MCU-Link host tools are installed, the following steps are
159    be done by installing :ref:`linkserver-debug-host-tools`.
183 This probe is programmed using the LPCScrypt host tools, which are installed
184 with the :ref:`linkserver-debug-host-tools`. NXP recommends using NXP's
185 `MCUXpresso Installer`_ to install the Linkserver tools.
203 This debug probe firmware is compatible with the following debug host tools:
205 - :ref:`linkserver-debug-host-tools`
210    be done by installing :ref:`linkserver-debug-host-tools`.
232 tools:
234 - :ref:`jlink-debug-host-tools`
241    be done by installing :ref:`linkserver-debug-host-tools`.
279 This debug probe firmware is compatible with the following debug host tools:
281 - :ref:`pyocd-debug-host-tools`
282 - :ref:`openocd-debug-host-tools`
283 - :ref:`linkserver-debug-host-tools`
288 Install the debug host tools before you program the firmware.
315 This debug probe is compatible with the following debug host tools:
317 - :ref:`jlink-debug-host-tools`
326 Install the debug host tools before you program the firmware.
356 This debug probe is compatible with the following debug host tools:
358 - :ref:`jlink-debug-host-tools`
359 - :ref:`openocd-debug-host-tools`
361 Install the debug host tools before you program the firmware.
373 It is compatible with the following host debug tools:
375 - :ref:`openocd-debug-host-tools`
376 - :ref:`jlink-debug-host-tools`
380 - :ref:`pyocd-debug-host-tools`
488 host tools as in indicated in :ref:`nxp-s32-debug-host-tools` before you program
516     https://www.st.com/en/development-tools/stm32cubeprog.html
522    https://www.nxp.com/design/software/automotive-software-and-tools/s32-debug-probe:S32-DP