Lines Matching refs:command

172 The command :code:`bap create_broadcast_sink` will either use existing periodic advertising
225 The command :code:`bap create_sink_by_name` will start scanning and sync to the periodic
278 command as such:
302 The :code:`init` command register local PAC records which are necessary to be
318 Once connected the :code:`discover` command discover PAC records and ASE
329    Use command :code:`gatt exchange-mtu` to make sure the MTU is configured
375 The :code:`preset` command can be used to either print the default preset
435 The :code:`bap preset` command can also be used to configure the preset used for the subsequent
436 commands. It is possible to add or set (or reset) any value. To reset the preset, the command can \
492 The :code:`config` command attempts to configure a stream for the given
523 The :code:`qos` command attempts to configure the stream QoS using the preset
540 The :code:`enable` command attempts to enable the stream previously configured.
556 The :code:`connect` command attempts to connect the stream previously configured.
573 The :code:`start` command is only necessary when starting a source stream.
588 The :code:`disable` command attempts to disable the stream previously enabled,
605 The :code:`stop` command is only necessary when acting as a sink as it indicates
621 The :code:`release` command releases the current stream and its configuration.
636 The :code:`list` command list the available streams.
652 The :code:`select_unicast` command set a unicast stream as default.
676 The :code:`send` command sends data over BAP Stream.