Lines Matching full:segment

21 sent as a single-segment segmented message when acknowledgment by the lower transport layer is
23 transmission and acknowledge single-segment segmented messages.
44 SAR does not impose extra overhead on the access layer payload per segment.
59 Transmission of segments is separated by a segment transmission interval (see the
60 `SAR Segment Interval Step`_ state). Other configurable time intervals and delays available for the
65 * Segment reception interval (see the `SAR Receiver Segment Interval Step`_ state).
68 When the last segment marked as unacknowledged is transmitted, the lower transport layer starts a
84 When the lower transport layer receives a message segment, it starts a SAR Discard timer. The
86 the segment belongs to. The initial value of the SAR Discard timer is the discard timeout value
89 SAR Acknowledgment timer holds the time before a Segment Acknowledgment message is sent for a
90 received segment. The initial value of the SAR Acknowledgment timer is calculated using the
95    min(SegN + 0.5 , acknowledgment~delay~increment) \times segment~reception~interval
108 `SAR Segments Threshold`_ state, Segment Acknowledgment messages are retransmitted using the value
124 * SAR Segment Interval Step
132 The SAR Receiver state is a composite state that controls the number and timing of Segment
140 * SAR Receiver Segment Interval Step
142 SAR Segment Interval Step
145 SAR Segment Interval Step state holds a value that controls the interval between transmissions of
149 value. Segment transmission interval is then calculated using the following formula:
243 transmission of an acknowledgment message after receiving a new segment. The increment is measured
264 The SAR Acknowledgment Retransmissions Count state controls the number of retransmissions of Segment
271 value for this state.  The maximum number of transmissions of a Segment Acknowledgment message is
274 SAR Receiver Segment Interval Step
277 The SAR Receiver Segment Interval Step defines the segments reception interval step used for
278 delaying the transmission of an acknowledgment message after receiving a new segment. The interval