Lines Matching +full:feature +full:- +full:specific

6 With Bluetooth Mesh Protocol Specification version 1.1, the Bluetooth Mesh Subnet Bridge feature was
8 This feature allows mesh networks to use subnets for area isolation, but to also allow communication
9 between specific devices in different, adjacent subnets without compromising security.
11 The Bluetooth Mesh Subnet Bridge feature makes it possible for selected nodes in the network to act
15 The Subnet Bridge feature includes two models:
17 - :ref:`bluetooth_mesh_models_brg_cfg_srv`
18 - :ref:`bluetooth_mesh_models_brg_cfg_cli`
20 The Bridge Configuration Server model is mandatory for supporting the Subnet Bridge feature.
24 Subnet Bridge feature.
26 The configuration and management of the Subnet Bridge feature are handled using the Bridge
29 the Subnet Bridge feature.
34 To get a better understanding of the Subnet Bridge feature and its capabilities, an overview of a
67 Enabling or disabling the Subnet Bridge feature
71 feature on a node by sending a **Subnet Bridge Set** message to the Bridge Configuration
89 - *Subnet Bridge*: This state indicates whether the Subnet Bridge feature is enabled or disabled on
94 - *Bridging Table*: This state holds the bridging table. The Client can request a list of
102 - *Bridging Table Size*: This state reports the maximum number of entries the Bridging Table can
105   This is a read-only state.
110 The Subnet Bridge feature enables message relaying between subnets and requires effective replay
124 Both the relay buffer pool and advertising sets can be used even if the relay feature
135 - The Subnet Bridge stores the latest IVISeq for each source address authorized to send messages to
138 - Messages with an IVISeq less than or equal to the stored value are discarded, while valid messages
155 forwarding, the current implementation does not support this feature.