Lines Matching refs:Target

7 sending BLOBs of any size to any number of Target nodes, in both Push BLOB Transfer Mode and Pull
65 address, instead of being sent individually to each Target node. Mesh Manager must ensure that all
66 Target nodes having the BLOB Transfer Server model subscribe to this group address.
69 BLOB Transfer Client sends each message to all Target nodes at the same time. However, sending
73 losing Target nodes. Using group addresses for BLOB transfers will generally only pay off if the
74 list of Target nodes is extensive, and the effectiveness of each addressing strategy will vary
80 If a Target node fails to respond to an acknowledged message within the BLOB Transfer Client's time
81 limit, the Target node is dropped from the transfer. The application can reduce the chances of this
88 * All Target nodes have responded.
89 * A node has been removed from the list of Target nodes.
98 procedure populates the transfer capabilities from all Target nodes with the most liberal set of
99 parameters that allows all Target nodes to participate in the transfer. Any Target nodes that fail
102 Target nodes are prioritized according to their order in the list of Target nodes. If a Target node
103 is found to be incompatible with any of the previous Target nodes, for instance by reporting a
104 non-overlapping block size range, it will be dropped. Lost Target nodes will be reported through the
120 The transfer runs until it either completes successfully for at least one Target node, or it is
122 <bt_mesh_blob_cli_cb.end>` callback. Lost Target nodes will be reported through the