Lines Matching refs:commands

8 This document describes a set of vendor specific HCI commands and events for
19 The Supported Commands configuration parameter lists which vendor commands the
50 Only Read_Version_Information and Read_Supported_Commands commands are
58 that either extend commands or don't have a vendor command. Most features are
157 Vendor specific HCI commands use the OGF 0x3F. All defined OCF are listed
251 This command reads the list of vendor commands supported for the local
284 	|                    | commands shall be set to 0           |
305 features list is only used for features not covered by supported commands.
380 The Host shall not send additional HCI commands before the Command Complete
504 This commands reads the controller firmware build information string.
538 This commands reads the controller specific static addresses.
608 This commands reads the controller specific identify and encryption root keys.
668 This commands reads the controller chip temperature.
705 commands supported for the local Controller.
718 commands. They are defined based on a vendor identifier and a base opcode.
720 With this command it is possible to incorporate external defined HCI commands
722 Controller commands. See Android [1][2] and Microsoft [3] defined extensions.
725 command set. Ideally all external commands are multiplexed through that single
740 	| 0xXX               | Total number of commands             |
747 	| 0x0001             | Android specific HCI commands        |
748 	| 0x0002             | Microsoft specific HCI commands      |
766 This commands configures the report of Scan_Request_Received events.
1039 	|                    | endpoints for commands, events and   |