Lines Matching full:linker

6 # Basic linker properties which should always be applied for a Zephyr build.
7 set_property(TARGET linker PROPERTY base)
10 # Basic linker properties which should always be applied for a Zephyr build
12 set_property(TARGET linker PROPERTY cpp_base)
15 set_property(TARGET linker PROPERTY baremetal)
17 # Property for controlling linker reporting / handling when placing orphaned sections.
18 set_property(TARGET linker PROPERTY orphan_warning)
19 set_property(TARGET linker PROPERTY orphan_error)
21 # coverage is a property holding the linker flag required for coverage support on the toolchain.
24 set_property(TARGET linker PROPERTY coverage)
26 # Linker flag for printing of memusage.
27 # Set this flag if the linker supports reporting of memusage as part of link,
31 check_set_linker_property(TARGET linker PROPERTY memusage)
34 set_property(TARGET linker PROPERTY warnings_as_errors)
36 # Linker flag for disabling position independent binaries,
38 set_property(TARGET linker PROPERTY no_position_independent)
40 # Linker flag for doing partial linking
42 set_property(TARGET linker PROPERTY partial_linking)
44 # Linker flag for section sorting by alignment
45 set_property(TARGET linker PROPERTY sort_alignment)
47 # Linker flag for disabling relaxation of address optimization for jump calls.
48 set_property(TARGET linker PROPERTY no_relax)
50 # Linker flag for enabling relaxation of address optimization for jump calls.
51 set_property(TARGET linker PROPERTY relax)
53 # Linker flag for defining specs. Defined only by gcc, when gcc is used as