Lines Matching +full:smps +full:- +full:mode
6 STM32WB5MMG is an ultra-low-power and small form factor certified 2.4 GHz
10 module on other boards as HCI layer (Specefically B-U585I-IOT02A Development board).
14 - Bluetooth module in SiP-LGA86 package
15 - Integrated chip antenna
16 - Bluetooth|reg| Low Energy 5.4, Zigbee|reg| 3.0, OpenThread certified
18 - IEEE 802.15.4-2011 MAC PHY Supports 2 Mbits/s
19 - Frequency band 2402-2480 MHz
20 - Advertising extension
21 - Tx output power up to +6 dBm
22 - Rx sensitivity: -96 dBm (Bluetooth|reg| Low Energy at 1 Mbps), -100 dBm (802.15.4)
23 - Range: up to 75 meters
24 - Dedicated Arm|reg| Cortex|reg|-M0+ CPU for radio and security tasks
25 - Dedicated Arm|reg| Cortex|reg|-M4 CPU with FPU and ART (adaptive real-time accelerator) up to 64 …
26 - 1-Mbyte flash memory, 256-Kbyte SRAM
27 - Fully integrated BOM, including 32 MHz radio and 32 kHz RTC crystals
28 - Integrated SMPS
29 - Ultra-low-power modes for battery longevity
30 - 68 GPIOs
31 - SWD, JTAG
38 STM32WB5MMG is an ultra-low-power and small form factor certified 2.4 GHz
42 provides best-in-class RF performance thanks to its high receiver sensitivity
43 and output power signal. Its low-power features enable extended battery life,
44 small coin-cell batteries, and energy harvesting. STM32WB5MMG revision Y is
48 - Ultra-low-power with FlexPowerControl (down to 600 nA Standby mode with RTC and 32KB RAM)
49 - Core: ARM |reg| 32-bit Cortex |reg|-M4 CPU with FPU, frequency up to 64 MHz
50 - Radio:
52 - 2.4GHz
53 - RF transceiver supporting Bluetooth|reg| 5.4
54 specification, IEEE 802.15.4-2011 PHY
56 - Zigbee|reg| 3.0
57 - RX sensitivity: -96 dBm (Bluetooth |reg| Low
58 Energy at 1 Mbps), -100 dBm (802.15.4)
59 - Programmable output power up to +6 dBm
61 - Integrated balun to reduce BOM
62 - Support for 2 Mbps
63 - Support GATT caching
64 - Support EATT (enhanced ATT)
65 - Support advertising extension
66 - Dedicated Arm|reg| 32-bit Cortex|reg| M0+ CPU
67 for real-time Radio layer
68 - Accurate RSSI to enable power control
69 - Suitable for systems requiring compliance
72 and ARIB STD-T66
75 - Clock Sources:
77 - 32 MHz crystal oscillator with integrated
79 - 32 kHz crystal oscillator for RTC (LSE)
80 - Internal low-power 32 kHz (±5%) RC (LSI1)
81 - Internal low-power 32 kHz (stability
83 - Internal multispeed 100 kHz to 48 MHz
84 oscillator, auto-trimmed by LSE (better than
86 - High speed internal 16 MHz factory
88 - 2x PLL for system clock, USB, SAI, ADC
90 - 2x DMA controllers (seven channels each) supporting ADC, SPI, I2C, USART, QSPI, SAI, AES, timers
91 - 1x USART (ISO 7816, IrDA, SPI master, Modbus and Smartcard mode)
92 - 1x LPUART (low power)
93 - Two SPI running at 32 Mbit/s
94 - 2x I2C (SMBus/PMBus)
95 - 1x SAI (dual channel high quality audio)
96 - 1x USB 2.0 FS device, crystal-less, BCD and LPM
97 - 1x Touch sensing controller, up to 18 sensors
98 - 1x LCD 8x40 with step-up converter
99 - 1x 16-bit, four channels advanced timer
100 - 2x 16-bit, two channels timers
101 - 1x 32-bit, four channels timer
102 - 2x 16-bit ultra-low-power timers
103 - 1x independent Systick
104 - 1x independent watchdog
105 - 1x window watchdog
106 - Up to 72 fast I/Os, 70 of them 5 V-tolerant
108 - Memories
110 - Up to 1 MB flash memory with sector
114 - Up to 256 KB SRAM, including 64 KB with
116 - 20x 32-bit backup register
117 - Boot loader supporting USART, SPI, I2C
119 - OTA (over the air) Bluetooth® Low Energy
121 - Quad SPI memory interface with XIP
122 - 1 Kbyte (128 double words) OTP
124 - 4x digital filters for sigma delta modulator
125 - Rich analog peripherals (down to 1.62 V)
127 - 12-bit ADC 4.26 Msps, up to 16-bit with
129 - 2x ultra-low-power comparator
130 - Accurate 2.5 V or 2.048 V reference
134 - Security and ID
136 - Secure firmware installation (SFI) for
138 - 3x hardware encryption AES maximum 256-bit for
140 - Low Energy and IEEE802.15.4
141 - Customer key storage/manager services
142 - HW public key authority (PKA)
143 - Cryptographic algorithms: RSA, Diffie-Helman, ECC over GF(p)
144 - True random number generator (RNG)
145 - Sector protection against R/W operation (PCROP)
146 - CRC calculation unit
147 - Die information: 96-bit unique ID
148 - IEEE 64-bit unique ID, possibility to derive 802.15.4 64-bit
150 - 48-bit EUI
154 - `STM32WB5MMG on www.st.com`_
155 - `STM32WB5MMG datasheet`_
162 +-----------+------------+-------------------------------------+
165 | UART | on-chip | serial port-polling; |
166 | | | serial port-interrupt |
167 +-----------+------------+-------------------------------------+
168 | RADIO | on-chip | Bluetooth Low Energy |
169 +-----------+------------+-------------------------------------+
180 To operate bluetooth on STM32WB5MMG, Cortex-M0 core should be flashed with
196 ----------------------------------
198 .. rst-class:: rst-columns
200 - UART_1 TX/RX : PB7/PB6
201 - LPUART_1 TX/RX : PA3/PA2
202 - USB : PA11/PA12
203 - SWD : PA13/PA14
206 ------------
212 -----------
230 The onboard ST-Link on the ``b_u585i_iot02a`` board can be used to flash the
231 STM32WB5MMG module. To do this you should put SW4 on OFF and SW5 on ON mode.
235 so its :ref:`installation <stm32cubeprog-flash-host-tools>` is required.
238 the ``--runner`` (or ``-r``) option:
240 .. code-block:: console
242 $ west flash --runner openocd
245 ------------------------------------------------
247 Connect the B-U585I-IOT02A to your host computer using the USB port. Put
248 the SW4 (MCU SWD) in OFF mode and SW5 (SWD BLE) in ON mode. Then build
250 :zephyr:code-sample:`bluetooth_hci_uart` application.
252 Run a serial host program to connect with your B-U585I-IOT02A board:
254 .. code-block:: console
256 $ minicom -D /dev/ttyACM0
260 .. zephyr-app-commands::
261 :zephyr-app: samples/bluetooth/hci_uart
265 Next, reverse back the buttons to default mode (SW4 on ON and SW5
266 on OFF) mode. In this case we will upload the Bluetooth sample on the
269 B-U585I-IOT02A board:
271 .. zephyr-app-commands::
272 :zephyr-app: samples/bluetooth/observer
278 .. code-block:: console
283 Device found: 2C:98:F3:64:58:06 (random) (RSSI -82), type 3, AD data len 31
284 Device found: CE:5B:9A:87:69:4F (random) (RSSI -80), type 3, AD data len 8
285 Device found: 7B:1E:DD:38:23:E1 (random) (RSSI -85), type 0, AD data len 17
292 :zephyr:code-sample:`bluetooth_hci_uart` application.
294 .. zephyr-app-commands::
295 :zephyr-app: samples/bluetooth/observer
297 :maybe-skip-config:
301 https://www.st.com/en/microcontrollers-microprocessors/stm32wb5mmg.html
307 https://github.com/zephyrproject-rtos/hal_stm32/blob/main/lib/stm32wb/hci/README
310 https://www.st.com/en/development-tools/stm32cubeprog.html