Lines Matching +full:vsync +full:- +full:pin
7 from audio, multi-sensor support, graphics, security, security, video,
8 and high-speed connectivity features. Important board features include:
10 - STM32F746NGH6 microcontroller featuring 1 Mbytes of Flash memory and 340 Kbytes of RAM, in BGA216…
11 - On-board ST-LINK/V2-1 supporting USB re-enumeration capability
12 - Five power supply options:
14 - ST LINK/V2-1
15 - USB FS connector
16 - USB HS connector
17 - VIN from Arduino connector
18 - External 5 V from connector
20 - Two pushbuttons (user and reset)
21 - USB functions: virtual COM port, mass storage, debug port
22 - 4.3-inch 480x272 color LCD-TFT with capacitive touch screen
23 - SAI audio codec
24 - Audio line in and line out jack
25 - Stereo speaker outputs
26 - Two ST MEMS microphones
27 - SPDIF RCA input connector
28 - 128-Mbit Quad-SPI Flash memory
29 - 128-Mbit SDRAM (64 Mbits accessible)
30 - Connector for microSD card
31 - USB OTG HS with Micro-AB connectors
32 - USB OTG FS with Micro-AB connectors
33 - Ethernet connector compliant with IEEE-802.3-2002
35 More information about the board can be found at the `32F746G-DISCO website`_.
42 - STM32F746NGH6 in BGA216 package
43 - ARM |reg| 32-bit Cortex |reg| -M7 CPU with FPU
44 - 216 MHz max CPU frequency
45 - VDD from 1.8 V to 3.6 V
46 - 2 MB Flash
47 - 384+4 KB SRAM including 64-Kbyte of core coupled memory
48 - GPIO with external interrupt capability
49 - LCD parallel interface, 8080/6800 modes
50 - LCD TFT controller supporting up to XGA resolution
51 - MIPI |reg| DSI host controller supporting up to 720p 30Hz resolution
52 - 3x12-bit ADC with 24 channels
53 - 2x12-bit D/A converters
54 - RTC
55 - Advanced-control Timer
56 - General Purpose Timers (17)
57 - Watchdog Timers (2)
58 - USART/UART (8)
59 - I2C (3)
60 - SPI (6)
61 - 1xSAI (serial audio interface)
62 - SDIO
63 - 2xCAN
64 - USB 2.0 OTG FS with on-chip PHY
65 - USB 2.0 OTG HS/FS with dedicated DMA, on-chip full-speed PHY and ULPI
66 - 10/100 Ethernet MAC with dedicated DMA
67 - 8- to 14-bit parallel camera
68 - CRC calculation unit
69 - True random number generator
70 - DMA Controller
74 - `STM32F746NGH6 on www.st.com`_
75 - `STM32F74xxx reference manual`_
82 +-----------+------------+-------------------------------------+
85 | NVIC | on-chip | nested vector interrupt controller |
86 +-----------+------------+-------------------------------------+
87 | UART | on-chip | serial port-polling; |
88 | | | serial port-interrupt |
89 +-----------+------------+-------------------------------------+
90 | PINMUX | on-chip | pinmux |
91 +-----------+------------+-------------------------------------+
92 | GPIO | on-chip | gpio |
93 +-----------+------------+-------------------------------------+
94 | FLASH | on-chip | flash memory |
95 +-----------+------------+-------------------------------------+
96 | ETHERNET | on-chip | Ethernet |
97 +-----------+------------+-------------------------------------+
98 | PWM | on-chip | pwm |
99 +-----------+------------+-------------------------------------+
100 | I2C | on-chip | i2c |
101 +-----------+------------+-------------------------------------+
102 | USB | on-chip | usb |
103 +-----------+------------+-------------------------------------+
104 | SDMMC | on-chip | disk access |
105 +-----------+------------+-------------------------------------+
106 | SPI | on-chip | spi |
107 +-----------+------------+-------------------------------------+
108 | QSPI NOR | on-chip | off-chip flash |
109 +-----------+------------+-------------------------------------+
110 | FMC | on-chip | memc (SDRAM) |
111 +-----------+------------+-------------------------------------+
112 | LTDC | on-chip | display |
113 +-----------+------------+-------------------------------------+
120 Pin Mapping
123 STM32F746G Discovery kit has 9 GPIO controllers. These controllers are responsible for pin muxing,
124 input/output, pull-up, etc.
126 For more details please refer to `32F746G-DISCO board User Manual`_.
129 ----------------------------------
134 - UART_1 TX/RX : PA9/PB7 (ST-Link Virtual Port Com)
135 - UART_6 TX/RX : PC6/PC7 (Arduino Serial)
136 - I2C1 SCL/SDA : PB8/PB9 (Arduino I2C)
137 - SDMMC_1 D0/D1/D2/D3/CK/CD/CMD: PC8/PC9/PC10/PC11/PC12/PC13/PD2
138 - SPI2 NSS/SCK/MISO/MOSI : PA8/PI1/PB14/PB15 (Arduino SPI)
139 - PWM_3_CH1 : PB4
140 - ETH : PA1, PA2, PA7, PC1, PC4, PC5, PG11, PG13, PG14
141 - USER_PB : PI11
142 - LD1 : PI1
143 - USB DM : PA11
144 - USB DP : PA12
145 - FMC SDRAM :
147 - D0-D15 : PD14/PD15/PD0/PD1/PE7/PE8/PE9/PE10/PE11/PE12/PE13/PE14/PE15/PD8/PD9/PD10
148 - A0-A11 : PF0/PF1/PF2/PF3/PF4/PF5/PF12/PF13/PF14/PF15/PG0/PG1
149 - A14/A15 : PG4/PG5
150 - SDNRAS/SDNCAS : PF11/PG15
151 - NBL0/NBL1 : PE0/PE1
152 - SDCLK/SDNWE/SDCKE0/SDNE0 : PG8/PH5/PC3/PH3
154 - LTDC :
156 - R0-R7 : PI15/PJ0/PJ1/PJ2/PJ3/PJ4/PJ5/PJ6
157 - G0-G7 : PJ7/PJ8/PJ9/PJ10/PJ11/PK0/PK1/PK2
158 - B0-B7 : PJ12/PK13/PJ14/PJ15/PK3/PK4/PK5/PK6
159 - DE/CLK/HSYNC/VSYNC : PK7/PI14/PI12/PI13
173 which connected to the onboard ST-LINK/V2 Virtual COM port interface. Default communication
179 STM32F746G Discovery kit includes an ST-LINK/V2 embedded debug tool interface.
189 so its :ref:`installation <stm32cubeprog-flash-host-tools>` is required.
192 the ``--runner`` (or ``-r``) option:
194 .. code-block:: console
196 $ west flash --runner openocd
197 $ west flash --runner jlink
200 -------------------------------------------
205 Here is an example for the :zephyr:code-sample:`hello_world` application.
207 .. zephyr-app-commands::
208 :zephyr-app: samples/hello_world
214 .. code-block:: console
216 $ minicom -D /dev/ttyACM0
220 .. code-block:: console
228 :zephyr:code-sample:`hello_world` application.
230 .. zephyr-app-commands::
231 :zephyr-app: samples/hello_world
236 .. _32F746G-DISCO website:
237 https://www.st.com/en/evaluation-tools/32f746gdiscovery.html
239 .. _32F746G-DISCO board User Manual:
243 …tent/st_com/en/products/microcontrollers/stm32-32-bit-arm-cortex-mcus/stm32-high-performance-mcus/…
249 https://www.st.com/en/development-tools/stm32cubeprog.html