Lines Matching full:with
12 open development platform with a wide choice of specialized shields.
16 The STM32 Nucleo-144 board comes with the STM32 comprehensive free software
17 libraries and examples available with the STM32Cube MCU Package.
21 - STM32 microcontroller with 64Kbytes of flash and 620Kbytes of RAM in TFBGA225 package
22 - Ethernet compliant with IEEE-802.3-2002
29 - USB with Micro-AB or USB Type-C®
31 - MIPI20 compatible connector with trace signals
35 - On-board ST-LINK/V3 debugger/programmer with USB re-enumeration
49 - Core: ARM |reg| 32-bit Cortex |reg| -M7 CPU with TrustZone |reg| and FPU.
56 - Arm |reg| TrustZone |reg| with ARMv8-M mainline security extension
59 - Flexible lifecycle scheme with secure debug authentication
62 - Secure data storage with hardware unique key (HUK)
63 - Secure firmware upgrade support with TF-M
64 - 2x AES coprocessors including one with DPA resistance
80 - Internal 48 MHz (HSI48) with recovery system
85 - Embedded regulator (LDO) with three configurable range output to supply the digital circuitry
88 - RTC with HW calendar, alarms and calibration
89 - Up to 152 fast I/Os, most 5 V-tolerant, up to 10 I/Os with independent supply down to 1.08 V
93 …- 4x 32-bit timers with up to 4 IC/OC/PWM or pulse counter and quadrature (incremental) encoder in…
102 - 640 KB of SRAM including 64 KB with hardware parity check and 320 Kbytes with flexible ECC
104 …- Flexible external memory controller with up to 16-bit data bus: SRAM, PSRAM, FRAM, SDRAM/LPSDR S…
105 …- 2x OCTOSPI memory interface with on-the-fly decryption and support for serial PSRAM/NAND/NOR, Hy…
106 …- 1x HEXASPI memory interface with on-the-fly decryption and support for serial PSRAM/NAND/NOR, Hy…
111 - 2x 12-bit ADC with up to 5 MSPS in 12-bit
117 - 1x USB OTG full-speed with PHY
118 - 1x USB OTG high-speed with PHY
123 - 6x SPIs including 3 muxed with full-duplex I2S
130 - 1x Ethernel MAC interface with DMA controller
195 Check if your ST-LINK V3 has newest FW version. It can be done with `STM32CubeProgrammer`_
218 Run a serial host program to connect with your NUCLEO-H7S3L8 board.
277 .. _OpenOCD installing with ST-LINK V3 support: