Lines Matching +full:a0 +full:- +full:low

1 .. _x-nucleo-idb05a1:
3 X-NUCLEO-IDB05A1: BLE expansion board
8 The X-NUCLEO-IDB05A1 is a Bluetooth Low Energy evaluation board based on the
9 SPBTLE-RF BlueNRG-MS RF module to allow expansion of the STM32 Nucleo boards.
10 The SPBTLE-RF module is FCC (FCC ID: S9NSPBTLERF) and IC certified
11 (IC: 8976C-SPBTLERF).
13 The X-NUCLEO-IDB05A1 is compatible with the ST Morpho and Arduino UNO R3
15 X-NUCLEO-IDB05A1 interfaces with the host microcontroller via the SPI pin, and
23 .. image:: img/x-nucleo-idb05a1.jpg
25      :alt: X-NUCLEO-IDB05A1
28 `X-NUCLEO-IDB05A1 website`_.
33 Out of the box, X-NUCLEO-IDB05A1 shield expects SPI SCK to be available on
40 see cs-gpios in x_nucleo_idb05a1.overlay
45  - SPI SCK: to use D13 instead of D3, remove R4 and add R6
50  - CS: To use D10 instead of A1, remove R2 and add R7
51  - IRQ: To use D9 instead of A0, remove R1 and add R8
53 You could check Figure 3 in `X-NUCLEO-IDB05A1 databrief`_ for more details.
62 X-NUCLEO-IDB05A1 provides a SPBTLE-RF chip with the following key features:
64  - Bluetooth Low Energy FCC and IC certified module based on Bluetooth ® SMART
65    4.1 network processor BlueNRG-MS
66  - Integrated Balun (BALF-NRG-01D3)
67  - Chip antenna
69 More information about X-NUCLEO-IDB05A1 can be found here:
70        - `X-NUCLEO-IDB05A1 databrief`_
75 You can use the X-NUCLEO-IDB05A1 as a Bluetooth Low-Energy controller
76 shield with an SPI host controller interface (HCI-SPI).  Activate the presence
77 of the shield for the project build by adding the ``--shield`` arg to the
80  .. zephyr-app-commands::
88 .. code-block:: cmake
95 .. target-notes::
97 .. _X-NUCLEO-IDB05A1 website:
98    https://www.st.com/en/ecosystems/x-nucleo-idb05a1.html
100 .. _X-NUCLEO-IDB05A1 databrief:
101    https://www.st.com/resource/en/data_brief/x-nucleo-idb05a1.pdf