Lines Matching +full:display +full:- +full:inversion

3 Sharp memory display generic shield
11 few other pins. Note that the SCS is active high for this display.
13 The DISP pin controls whether to display memory
15 directly to VDD, to always display memory contents or connected
16 to a gpio. If devicetree contains ``disp-en-gpios`` then it will be set to
17 high during driver initialization. Display blanking apis can be used
28 When ``extcomin-gpios`` is defined, driver starts a thread which will
29 toggle EXTCOMIN at ``extcomin-frequency`` frequency. Higher frequency
33 define ``extcomin-gpios`` and implement their preferred method in
36 Pins Assignment of the Generic Sharp memory Display Shield
39 +---------------+---------------------------------------------------------+
43 +---------------+---------------------------------------------------------+
45 +---------------+---------------------------------------------------------+
47 +---------------+---------------------------------------------------------+
48 | EXTCOMIN      | VCOM Inversion Polarity Input (VCOM can be controlled   |
50 +---------------+---------------------------------------------------------+
51 | DISP          | Display ON/OFF switching signal (Can be connected       |
53 +---------------+---------------------------------------------------------+
54 | EXTMODE       | COM Inversion Selection                                 |
55 +---------------+---------------------------------------------------------+
74 +----------------------+------------------------------+
75 | Display              | Shield Designation           |
79 +----------------------+------------------------------+
91 Set ``--shield ls013b7dh03`` when you invoke ``west build``. For example:
93 .. zephyr-app-commands::
94    :zephyr-app: samples/subsys/display/lvgl
102 .. target-notes::
108    https://www.mouser.com/datasheet/2/365/LS013B7DH03%20SPEC_SMA-224806.pdf