Lines Matching refs:debug
21 - Onboard, high-speed USB, Link2 debug probe with CMSIS-DAP protocol (supporting Cortex M33 debug o…
23 - UART, I2C and SPI port bridging from i.MX RT685 target to USB via the on-board debug probe
217 A debug probe is used for both flashing and debugging the board. This board is
224 1. Install the :ref:`linkserver-debug-host-tools` and make sure they are in your
234 west debug
239 1. Install the :ref:`jlink-debug-host-tools` and make sure they are in your search path.
240 2. To connect the SWD signals to onboard debug circuit, install jumpers JP17, JP18 and JP19,
242 3. Follow the instructions in :ref:`lpclink2-jlink-onboard-debug-probe` to program the
248 west debug -r jlink
253 1. Install the :ref:`jlink-debug-host-tools` and make sure they are in your search path.
255 2. To disconnect the SWD signals from onboard debug circuit, **remove** jumpers J17, J18,
260 See :ref:`jlink-external-debug-probe` for more information.
265 west debug -r jlink
282 :ref:`linkserver-debug-host-tools` as default.
301 :ref:`linkserver-debug-host-tools` as default.
306 :goals: debug
319 If the debug probe fails to connect with the following error, it's possible
339 #. Run ``west debug`` or ``west flash`` again with a known working Zephyr