Lines Matching +full:open +full:- +full:wire

9 The IT82XX2 is a 32-bit RISC-V microcontroller.
26 - RISC-V RV32IMAFC instruction set
27 - 4KB instruction cache size
28 - 256KB SRAM in total
29 - Built-in 32.768 kHz clock generator
30 - Embedded Flash, 512K/1024K-byte e-flash
31 - eSPI, SSPI, SPI slave, BRAM, KBC, PECI, UART
32 - GPIO, PWM, ADC, INTC, WUC, Timer, Watchdog, KB scan, JTAG
33 - Support 6 Voltage Comparator
34 - Support Cryptographic Engine
35 - 6 SMBus channels, with 6 DMA controller, compatible with I2C
36 - USB 2.0 Full-speed Controller
37 - USB Type-c CC Logic
38 - USB Power Delivery
45 .. list-table:: Supported Features
46    :header-rows: 1
49    * - Interface
50      - Controller
51      - Driver/Component
52    * - NVIC
53      - on-chip
54      - interrupt controller
55    * - FLASH
56      - on-chip
57      - flash controller
58    * - PINCTRL
59      - on-chip
60      - pin controller
61    * - ESPI
62      - on-chip
63      - espi
64    * - PECI
65      - on-chip
66      - peci
67    * - UART
68      - on-chip
69      - serial
70    * - GPIO
71      - on-chip
72      - gpio
73    * - PWM
74      - on-chip
75      - pwm
76    * - ADC
77      - on-chip
78      - adc
79    * - TIMER
80      - on-chip
81      - timer
82    * - WATCHDOG
83      - on-chip
84      - watchdog
85    * - KSCAN
86      - on-chip
87      - kscan
88    * - SENSOR
89      - on-chip
90      - voltage comparator
91    * - I2C
92      - on-chip
93      - i2c
116 #. Connect the USB to UART wire to J33 on the evolution motherboard.
126     +-------------+---------------+
131     +-------------+---------------+
133     +-------------+---------------+
135     +-------------+---------------+
139     +-------------+---------------+
145     +-------------+---------------+
147     +-------------+---------------+
149     +-------------+---------------+
154 #. Build :zephyr:code-sample:`hello_world` application as you would normally do
157    .. zephyr-app-commands::
159       :zephyr-app: samples/hello_world
168 --------
173 #. Open the winflash tool and make sure the order you open the switch is right.
194    For example, open device manager to find the USB Serial Port(COM4) and use your
205 --------
212    .. code-block:: console
214       $ minicom -D /dev/ttyUSB0 -b 115200
216 #. Open a second terminal window and use the Linux flash tool to flash your board.
218    .. code-block:: console
220       $ sudo ~/itetool/ite -f build/zephyr/zephyr.bin
238 #. If the flash tool reports a failure, re-plug the 8390 Download board or
244 .. target-notes::
246 .. _ITE's website: https://www.ite.com.tw/zh-tw/product/view?mid=169