Lines Matching full:-
6 of the MAX32670. The MAX32670 is an ultra-low-power, cost-effective, highly reliable
7 32-bit microcontroller that enables designs with complex sensor processing without
9 with the powerful Arm® Cortex®-M4 core with floating point unit (FPU).
11 from 8-bit or 16-bit microcontrollers.
18 - MAX32670 MCU:
20 - High-Efficiency Microcontroller for Low-Power, High-Reliability Devices
22 - Arm Cortex-M4 Core with FPU up to 100MHz
23 - 384KB Flash Memory with Error Correction
24 - 160KB SRAM (128KB with ECC Enabled),Optionally Preserved in Lowest Power Modes
25 - 16KB Unified Cache with ECC
27 - UART Bootloader
29 - Dual- or Single-Supply Operation
30 - Ultra-Low 0.9V to 1.1V VCORE Supply Voltage
31 - Internal LDO Operation from 1.7V to 3.6V SingleSupply
33 - Wide Operating Temperature: -40°C to +105°C
35 - Flexible Clocking Schemes
37 - Internal High-Speed 100MHz Oscillator
38 - Internal Low-Power 7.3728MHz and Ultra-Low-Power 80kHz Oscillators
39 - 16MHz to 32MHz Oscillator (External CrystalRequired)
40 - 32.768kHz Oscillator (External Crystal Required)
41 - External Clock Input for the Core
42 - External Clock Input for the LPUART and LPTMR
44 - Power Management Maximizes Uptime for Battery Applications
46 - 44μA/MHz Active at 0.9V up to 12MHz
47 - 50μA/MHz Active at 1.1V up to 100MHz
48 - 2.6μA Full Memory Retention Power in BACKUPMode at VDD = 1.8V
49 - 350nA Ultra-Low-Power RTC at VDD = 1.8V
50 - Wake from LPUART or LPTMR
52 - Optimal Peripheral Mix Provides Platform Scalability
54 - Up to 31 General-Purpose I/O Pins
55 - Up to Three SPI Master/Slave (up to 50MHz)
56 - Up to Three 4-Wire UART
57 - One Low-Power UART (LPUART)
58 - Up to Three I2C Master/Slave 3.4Mbps High Speed
59 - 8-Channel Standard DMA Controller
60 - Up to Four 32-Bit Timers (TMR)
61 - Up to Two Low-Power 32-Bit Timers (LPTMR)
62 - Two Windowed Watchdog Timers
63 - One I2S Slave for Digital Audio Interface
65 - Security and Integrity
67 - Available Secure Boot
68 - AES 128/192/256 Hardware Acceleration Engine
69 - 32-Bit CRC Acceleration Engine
71 - Benefits and Features of MAX32670EVKIT:
73 - USB 2.0 Micro B to Serial UART Bridge
74 - UART0 and UART3 Interface is Selectable Through On-Board Jumpers
75 - On-Board MAX32625PICO-Based Debugger
76 - Boot Load Enable Circuitry
77 - SPI and I2C Signals Accessed Through 0.1in Headers
78 - GPIOs and Miscellaneous Signals Accessed Through 0.1in Headers
79 - Board Power Provided by USB Port
80 - On-Board SIMO Regulator and LDO for IC and Peripherals
81 - Individual Power Measurement on all IC Rails Through Jumpers
82 - Two General-Purpose LED and One GeneralPurpose Pushbutton Switch
89 +-----------+------------+-------------------------------------+
92 | NVIC | on-chip | nested vector interrupt controller |
93 +-----------+------------+-------------------------------------+
94 | SYSTICK | on-chip | systick |
95 +-----------+------------+-------------------------------------+
96 | CLOCK | on-chip | clock and reset control |
97 +-----------+------------+-------------------------------------+
98 | GPIO | on-chip | gpio |
99 +-----------+------------+-------------------------------------+
100 | UART | on-chip | serial |
101 +-----------+------------+-------------------------------------+
102 | TRNG | on-chip | entropy |
103 +-----------+------------+-------------------------------------+
104 | I2C | on-chip | i2c |
105 +-----------+------------+-------------------------------------+
106 | DMA | on-chip | dma controller |
107 +-----------+------------+-------------------------------------+
108 | Watchdog | on-chip | watchdog |
109 +-----------+------------+-------------------------------------+
110 | SPI | on-chip | spi |
111 +-----------+------------+-------------------------------------+
112 | Timer | on-chip | counter |
113 +-----------+------------+-------------------------------------+
114 | PWM | on-chip | pwm |
115 +-----------+------------+-------------------------------------+
116 | Flash | on-chip | flash |
117 +-----------+------------+-------------------------------------+
122 +-----------+---------------+---------------+------------------------------------------------------…
126 … | | +-----------+ | +-----------------------------------------------------…
128 … | | +-----------+ | +-----------------------------------------------------…
130 … | | +-----------+ | +-----------------------------------------------------…
132 +-----------+---------------+---------------+------------------------------------------------------…
133 …P2 | P0_23 | +-----------+ | +-----------------------------------------------------…
135 … | | +-----------+ | +-----------------------------------------------------…
137 … | | +-----------+ | +-----------------------------------------------------…
139 +-----------+---------------+---------------+------------------------------------------------------…
140 …P3 | P0_20 | +-----------+ | +-----------------------------------------------------…
141 | | P0_26 | | 2-1 | | | Connects the USB to serial port P0_8 (UART0_RX). …
142 … | | +-----------+ | +-----------------------------------------------------…
143 | | | | 2-3 | | | Connects the USB to serial port P0_26 (LPUART0_RX)…
144 … | | +-----------+ | +-----------------------------------------------------…
146 +-----------+---------------+---------------+------------------------------------------------------…
147 …P4 | P0_9 | +-----------+ | +-----------------------------------------------------…
148 | | P0_27 | | 2-1 | | | Connects the USB to serial port P0_9 (UART0_TX). …
149 … | | +-----------+ | +-----------------------------------------------------…
150 | | | | 2-3 | | | Connects the USB to serial port P0_27 (LPUART0_TX)…
151 … | | +-----------+ | +-----------------------------------------------------…
153 +-----------+---------------+---------------+------------------------------------------------------…
154 …P5 | VDD | +-----------+ | +-----------------------------------------------------…
156 … | | +-----------+ | +-----------------------------------------------------…
158 … | | +-----------+ | +-----------------------------------------------------…
160 +-----------+---------------+---------------+------------------------------------------------------…
161 …P6 | VCORE | +-----------+ | +-----------------------------------------------------…
163 … | | +-----------+ | +-----------------------------------------------------…
165 … | | +-----------+ | +-----------------------------------------------------…
167 +-----------+---------------+---------------+------------------------------------------------------…
168 …P7 | SIMO RSEL2 | +-----------+ | +-----------------------------------------------------…
169 | | | | 1-2 | | | Sets output 2 of the SIMO regulator to 0.9V. …
170 … | | +-----------+ | +-----------------------------------------------------…
171 | | | | 3-4 | | | Sets output 2 of the SIMO regulator to 1.0V. …
172 … | | +-----------+ | +-----------------------------------------------------…
173 | | | | 5-6 | | | Sets output 2 of the SIMO regulator to 1.1V. …
174 … | | +-----------+ | +-----------------------------------------------------…
176 +-----------+---------------+---------------+------------------------------------------------------…
199 - `MAX32670EVKIT web page`_
202 …https://www.analog.com/en/design-center/evaluation-hardware-and-software/evaluation-boards-kits/ma…