Lines Matching +full:open +full:- +full:wire +full:- +full:on
6 ultra low-power wireless solutions using MAX32655 Arm© Cortex®-M4F and Bluetooth® 5.2 Low Energy (L…
8 The form factor is a small 0.9in x 2.6in dual-row header footprint that is compatible
12 The MAX32655FTHR provides a power-optimized flexible platform for quick proof-of-concepts and
17 The Zephyr port is running on the MAX32655 MCU.
34 - MAX32655 MCU:
36 - Ultra-Low-Power Wireless Microcontroller
37 - Internal 100MHz Oscillator
38 - Flexible Low-Power Modes with 7.3728MHz System Clock Option
39 - 512KB Flash and 128KB SRAM (Optional ECC on One 32KB SRAM Bank)
40 - 16KB Instruction Cache
41 - Bluetooth 5.2 LE Radio
42 …- Dedicated, Ultra-Low-Power, 32-Bit RISC-V Coprocessor to Offload Timing-Critical Bluetooth Proce…
43 - Fully Open-Source Bluetooth 5.2 Stack Available
44 - Supports AoA, AoD, LE Audio, and Mesh
45 - High-Throughput (2Mbps) Mode
46 - Long-Range (125kbps and 500kbps) Modes
47 - Rx Sensitivity: -97.5dBm; Tx Power: +4.5dBm
48 - Single-Ended Antenna Connection (50Ω)
49 - Power Management Maximizes Battery Life
50 - 2.0V to 3.6V Supply Voltage Range
51 - Integrated SIMO Power Regulator
52 - Dynamic Voltage Scaling (DVS)
53 - 23.8μA/MHz Active Current at 3.0V
54 - 4.4μA at 3.0V Retention Current for 32KB
55 - Selectable SRAM Retention + RTC in Low-Power Modes
56 - Multiple Peripherals for System Control
57 - Up to Two High-Speed SPI Master/Slave
58 - Up to Three High-Speed I2C Master/Slave (3.4Mbps)
59 - Up to Four UART, One I2S Master/Slave
60 - Up to 8-Input, 10-Bit Sigma-Delta ADC 7.8ksps
61 - Up to Four Micro-Power Comparators
62 - Timers: Up to Two Four 32-Bit, Two LP, TwoWatchdog Timers
63 - 1-Wire® Master
64 - Up to Four Pulse Train (PWM) Engines
65 - RTC with Wake-Up Timer
66 - Up to 52 GPIOs
67 - Security and Integrity
68 - Available Secure Boot
69 - TRNG Seed Generator
70 - AES 128/192/256 Hardware Acceleration Engine
72 - External devices connected to the MAX32655FTHR:
74 - Audio Stereo Codec Interface
75 - Digital Microphone
76 - PMIC and Battery Charger
77 - A 128Mb QSPI flash
78 - Micro SDCard Interface
79 - RGB LEDs
80 - Push Buttons
85 Below are the interfaces supported by Zephyr on MAX32655FTHR.
87 +-----------+------------+-------------------------------------+
90 | NVIC | on-chip | nested vector interrupt controller |
91 +-----------+------------+-------------------------------------+
92 | SYSTICK | on-chip | systick |
93 +-----------+------------+-------------------------------------+
94 | CLOCK | on-chip | clock and reset control |
95 +-----------+------------+-------------------------------------+
96 | GPIO | on-chip | gpio |
97 +-----------+------------+-------------------------------------+
98 | UART | on-chip | serial |
99 +-----------+------------+-------------------------------------+
100 | TRNG | on-chip | entropy |
101 +-----------+------------+-------------------------------------+
102 | I2C | on-chip | i2c |
103 +-----------+------------+-------------------------------------+
104 | DMA | on-chip | dma controller |
105 +-----------+------------+-------------------------------------+
106 | Watchdog | on-chip | watchdog |
107 +-----------+------------+-------------------------------------+
108 | SPI | on-chip | spi |
109 +-----------+------------+-------------------------------------+
110 | ADC | on-chip | adc |
111 +-----------+------------+-------------------------------------+
112 | Timer | on-chip | counter |
113 +-----------+------------+-------------------------------------+
114 | PWM | on-chip | pwm |
115 +-----------+------------+-------------------------------------+
116 | Flash | on-chip | flash |
117 +-----------+------------+-------------------------------------+
121 There are six pushbuttons on the MAX32655FTHR board
125 PMIC Power Button, when the board is powered on state, pressing
127 When the board is in a powered-off state, pressing this button powers on the board.
129 is a buffered input of the button status. When the button is pressed, this signal goes to a logic-l…
134 User-programmable function button connected to
139 User-programmable function button connected to
144 Wake-up button connected to MAX32655 Port 3.1.
154 put the MAX32625 DAPLink adapter on board
161 There are three RGB LEDs on the MAX32655FTHR board
190 The MAX32625 microcontroller on the board is flashed with DAPLink firmware at the factory.
205 - `MAX32655FTHR web page`_
208 …https://www.analog.com/en/design-center/evaluation-hardware-and-software/evaluation-boards-kits/ma…