Lines Matching +full:blue +full:- +full:output +full:- +full:current
6 The EVAL-ADIN2111EBZ is a flexible platform enabling quick evaluation of the ADIN2111, robust,
7 low power 10BASE-T1L 2-Port Ethernet switch. The evaluation board provides 2 10BASE-T1L channels
10 The ADIN2111 internal switch can be configured in store and forward mode between the two 10BASE-T1L
19 Alternatively, the board can operate in cut-through mode between Port 1 and Port 2 (unmanaged
20 configuration without firmware) where the EVAL-ADIN2111EBZ acts as a network switch forwarding
21 packets between the 2x 10BASE-T1L ports. The 2x links are configured by setting the ADIN2111
22 hardware configuration pins jumper and switches. The 2x On-board Activity LEDs provide Link
33 S1 DIP switches are shipped in Open Alliance SPI mode. The current Zephyr
41 The ADI EVAL-ADIN2111EBZ hardware features list is available here:
43 https://wiki.analog.com/resources/eval/user-guides/eval-adin2111ebz-user-guide
52 +--------------+------------+-------------------------------------+
55 | NVIC | on-chip | nested vector interrupt controller |
56 +--------------+------------+-------------------------------------+
57 | UART | on-chip | serial port-polling; |
58 | | | serial port-interrupt |
59 +--------------+------------+-------------------------------------+
60 | PINMUX | on-chip | pinmux |
61 +--------------+------------+-------------------------------------+
62 | GPIO | on-chip | gpio |
63 +--------------+------------+-------------------------------------+
64 | I2C | on-chip | i2c |
65 +--------------+------------+-------------------------------------+
66 | SPI | on-chip | spi |
67 +--------------+------------+-------------------------------------+
68 | PWM | on-chip | pwm |
69 +--------------+------------+-------------------------------------+
70 | WATCHDOG | on-chip | independent watchdog |
71 +--------------+------------+-------------------------------------+
72 | ADIN2111 | spi | adin2111 10BASE-T1L mac/phy |
73 +--------------+------------+-------------------------------------+
74 | FT232 | uart | usb-uart |
75 +--------------+------------+-------------------------------------+
87 These controllers are responsible for pin muxing, input/output, pull-up, etc.
89 …tails please refer to `EVAL-ADIN2111EBZ User Guide <https://wiki.analog.com/resources/eval/user-gu…
92 ----------------------------------
94 - UART_1 TX/RX : PA9/PA10 (UART to FT232, console)
95 - SPI1 SCK/MISO/MOSI : PA5/PA6/PA7 (SPI to external nor flash IS25LP128)
96 - SPI2 SCK/MISO/MOSI : PB13/PB14/PB15 (SPI to external ADIN2111)
97 - LED1 : POWER (Green LED)
98 - UC_LED1 : PB6 (Blue LED)
99 - MOD LED1 : PE2 (SR LED)
100 - MOD LED2 : PE6 (BG LED)
101 - NET LED1 : PB10 (SR LED)
102 - NET LED2 : PB11 (BG LED)
106 ------------
108 EVAL-ADIN2111EBZ System Clock could be driven by an internal or external oscillator, as well as the
113 -----------
115 EVAL-ADIN2111EBZ has 1 U(S)ART. The Zephyr console output is assigned to UART1 that is connected
126 EVAL-ADIN2111EBZ includes an ST-LINK/V2-1 JTAG/SWD 10 or 20 pin connector. This interface is
130 -----------------------------------------
132 Connect the EVAL-ADIN2111EBZ to your host computer using the USB port, then run a serial host
135 .. code-block:: console
137 $ minicom -D /dev/serial/by-id/usb-ADI_EVAL-ADIN2111EBZ_XXXXXX-12-if00-port0
140 Then, build and flash in the usual way. Here is an example for the :zephyr:code-sample:`hello_world…
142 .. zephyr-app-commands::
143 :zephyr-app: samples/hello_world
149 .. code-block:: console
156 You can debug an application in the usual way. Here is an example for the :zephyr:code-sample:`hel…
159 .. zephyr-app-commands::
160 :zephyr-app: samples/hello_world
162 :maybe-skip-config:
165 .. _EVAL-ADIN2111EBZ evaluation board website:
166 …https://www.analog.com/en/design-center/evaluation-hardware-and-software/evaluation-boards-kits/ev…
168 .. _EVAL-ADIN2111EBZ board User Guide:
169 https://wiki.analog.com/resources/eval/user-guides/eval-adin2111ebz-user-guide
172 https://www.analog.com/media/en/technical-documentation/data-sheets/adin2111.pdf
175 …https://www.st.com/resource/en/reference_manual/rm0432-stm32l4-series-advanced-armbased-32bit-mcus…